*mydirectindustry

Catalogs
Labthink Instruments Co., Ltd.
i-Strentek 1100 Auto Tensile Tester---Trouser Tear Test

i-Strentek 1100 Auto Tensile Tester---Trouser Tear Test

Product catalog summary

Scope
The i-Strentek 1100 Auto Tensile Tester is a versatile device used to measure various mechanical properties such as tensile, peeling, tearing, and other forces in materials like plastic films, composite materials, flexible packaging, and more. It is applicable to a wide range of materials including adhesives, medical plasters, and non-woven fabrics.

Test Procedures

Specimen Preparation: Prepare test specimens according to specific standards, ensuring at least five specimens for both length and transverse directions. The specimens should be free of breaches or scratches.
Equipment Adjustment: Adjust the space between the upper and lower sample grips using the control keys to fit the specimen requirements. Mount the specimen using a pneumatic clamp.
Test Setup: Configure the test and specimen parameters, and select the appropriate test speed before initiating the test.
Data Recording: Observe and record the test data. If the test curve is unsatisfactory, discard the results and repeat the test with a new specimen until valid data is obtained.

Catalog excerpts

i-Strentek 1100 Auto Tensile Tester---Trouser Tear Test-1

i-Strentek 1100 Auto Tensile Tester---Trouser Tear Test Scope i-Strentek 1100 Auto Tensile Tester is designed to determine the tensile, peeling, tearing, heat sealing, adhesive, piercing, opening, low speed unwrapping and pulling force of the plastic film, composite material, flexible packaging material, plastic tube, adhesives, adhesive tapes, medical plasters, release paper, protective films, combination caps, aluminum foils, diaphragm, back sheets, non-woven fabrics, rubber and paper etc. Test Procedures A: Prepare test specimens according to specific standards. Select the shape and dimension of the specimen for tear test. No less than 5 specimens are required for both length direction and transverse direction. Make sure the cut slit is free of breach or scratches.

Open the catalog to page 1

i-Strentek 1100 Auto Tensile Tester---Trouser Tear Test-2

B: Adjust the space between upper sample grip and lower sample grip to meet the requirements of the specimen by pressing “Lower”, “Lift” and “Stop” keys. Then mount the specimen properly with pneumatic clamp. C: Set up test parameters, specimen parameters and select proper test speed. Then start the test.

Open the catalog to page 2

i-Strentek 1100 Auto Tensile Tester---Trouser Tear Test-3

200 River's Edge Drive, Medford, MA 02155

Open the catalog to page 3

All Labthink Instruments Co., Ltd. catalogs and technical brochures

Archived catalogs

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list