*mydirectindustry

Catalogs
Labthink Instruments Co., Ltd.
i-STRENTEK 1100 Auto Tensile Tester---Tensile Test

i-STRENTEK 1100 Auto Tensile Tester---Tensile Test

Product catalog summary

Scope
The i-STRENTEK 1100 Auto Tensile Tester is a versatile device designed to measure various mechanical properties such as tensile, peeling, tearing, and adhesive forces. It is applicable to a wide range of materials including plastic films, composite materials, flexible packaging, adhesives, medical plasters, and more.

Test Procedures

Specimen Preparation: Test specimens should be prepared according to specific standards, ensuring they are stripped, with flat and parallel edges. Anisotropic films require specimens in both horizontal and vertical orientations.
Equipment Setup: Adjust the space between the upper and lower sample grips using the control keys. Secure the specimen with a pneumatic clamp.
Test Execution: Configure the test and specimen parameters, select the appropriate test speed, and initiate the test.
Data Recording: Observe and document the test data. If the results are unsatisfactory or the specimen fails at the root, the test should be repeated with a new specimen.

Catalog excerpts

i-STRENTEK 1100 Auto Tensile Tester---Tensile Test-1

i-STRENTEK 1100 Auto Tensile Tester---Tensile Test Scope i-STRENTEK 1100 Auto Tensile Tester is designed to determine the tensile, peeling, tearing, heat sealing, adhesive, piercing, opening, low speed unwrapping and pulling force of the plastic film, composite material, flexible packaging material, plastic tube, adhesives, adhesive tapes, medical plasters, release paper, protective films, combination caps, aluminum foils, diaphragm, back sheets, non-woven fabrics, rubber and paper etc. Test Procedures A: Prepare test specimens according to specific standards. The shape and size of test specimen depend on the material of test specimen. Stripped specimen is preferred. The width of specimen should meet the requirement. The edges of the specimen should be flat and parallel to each other. The specimen with visible defect should be abandoned. The film may show anisotropy therefore it is necessary to prepare two groups of specimens both horizontally and vertically.

Open the catalog to page 1

i-STRENTEK 1100 Auto Tensile Tester---Tensile Test-2

B: Adjust the space between upper sample grip and lower sample grip to meet the requirements of the specimen by pressing “Lower”, “Lift” and “Stop” keys. Then mount the specimen properly with pneumatic clamp. C: Set up test parameters, specimen parameters and select proper test speed. Then start the test.

Open the catalog to page 2

i-STRENTEK 1100 Auto Tensile Tester---Tensile Test-3

D: View and record the test data. If the test curve is not satisfactory or the specimen fails from the root, the test should be abandoned and new test with another specimen should be started until proper test data could be obtained.

Open the catalog to page 3

All Labthink Instruments Co., Ltd. catalogs and technical brochures

Archived catalogs

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list