*mydirectindustry

Catalogs
Labthink Instruments Co., Ltd.
i-STRENTEK 1100 Auto Tensile Tester---Puncture Test

i-STRENTEK 1100 Auto Tensile Tester---Puncture Test

Product catalog summary

Scope
The i-STRENTEK 1100 Auto Tensile Tester is a versatile instrument designed to measure various mechanical properties such as tensile, peeling, tearing, heat sealing, adhesive, piercing, opening, low-speed unwrapping, and pulling forces. It is applicable to a wide range of materials including plastic films, composite materials, flexible packaging, plastic tubes, adhesives, tapes, medical plasters, release papers, protective films, combination caps, aluminum foils, diaphragms, back sheets, non-woven fabrics, rubber, and paper.

Test Procedures

Specimen Preparation: Prepare test specimens according to specific standards. Ensure the specimen is of uniform thickness and free from wrinkles, creases, grease, or other visible imperfections.
Equipment Setup: Install sample grips and the appropriate needle for the puncture test on the instrument.
Parameter Configuration: Set up the test parameters, including specimen parameters and test speed, then initiate the test.
Data Recording: View and record the test data. If the test curve is unsatisfactory, discard the test and repeat with a new specimen until satisfactory data is obtained.

Catalog excerpts

i-STRENTEK 1100 Auto Tensile Tester---Puncture Test-1

i-STRENTEK 1100 Auto Tensile Tester---Puncture Test Scope i-STRENTEK 1100 Auto Tensile Tester is designed to determine the tensile, peeling, tearing, heat sealing, adhesive, piercing, opening, low speed unwrapping and pulling force of the plastic film, composite material, flexible packaging material, plastic tube, adhesives, adhesive tapes, medical plasters, release paper, protective films, combination caps, aluminum foils, diaphragm, back sheets, non-woven fabrics, rubber and paper etc. Test Procedures A: Prepare test specimens according to specific standards. Then mount the specimen on to the fixture for puncture test. The specimen should be of uniform thickness and should be free of wrinkles, creases, grease or other visible imperfections.

Open the catalog to page 1

i-STRENTEK 1100 Auto Tensile Tester---Puncture Test-2

B: Install sample grips and proper needle for puncture test to the instrument. C: Set up test parameters, specimen parameters and select proper test speed. Then start the test.

Open the catalog to page 2

i-STRENTEK 1100 Auto Tensile Tester---Puncture Test-3

Open the catalog to page 3

All Labthink Instruments Co., Ltd. catalogs and technical brochures

Archived catalogs

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list