*mydirectindustry

Catalogs
Labthink Instruments Co., Ltd.
i-STRENTEK 1100 Auto Tensile Tester---Floating Roller Method Test

i-STRENTEK 1100 Auto Tensile Tester---Floating Roller Method Test

Product catalog summary

Scope
The i-STRENTEK 1100 Auto Tensile Tester is a versatile device designed to measure various mechanical properties such as tensile, peeling, tearing, and adhesive forces of materials including plastic films, composite materials, flexible packaging, and more. It is particularly used for determining the peel resistance of high-strength adhesive bonds using the floating roller method.

Test Procedures

Specimen Preparation: Test specimens must be prepared according to specific standards, ensuring uniform thickness and absence of visible imperfections.
Equipment Adjustment: Adjust the space between the upper and lower sample grips to fit the specimen by using the 'Lower', 'Lift', and 'Stop' keys. Secure the specimen with a pneumatic clamp.
Parameter Setup: Configure the test and specimen parameters, and select the appropriate test speed before initiating the test.
Data Recording: Observe and record the test data. If the test curve is unsatisfactory, discard the test and repeat with a new specimen until valid data is obtained.

Catalog excerpts

i-STRENTEK 1100 Auto Tensile Tester---Floating Roller Method Test-1

i-STRENTEK 1100 Auto Tensile Tester---Floating Roller Method Test Scope i-STRENTEK 1100 Auto Tensile Tester is designed to determine the tensile, peeling, tearing, heat sealing, adhesive, piercing, opening, low speed unwrapping and pulling force of the plastic film, composite material, flexible packaging material, plastic tube, adhesives, adhesive tapes, medical plasters, release paper, protective films, combination caps, aluminum foils, diaphragm, back sheets, non-woven fabrics, rubber and paper etc. Floating roller method test is to determine the peel resistance of high-strength adhesive bonds. Test Procedures A: Prepare test specimens according to specific standards. The test specimen should be of uniform thickness and should be free of any visible imperfection. B: Adjust the space between upper sample grip and lower sample grip to meet the requirements of the specimen by pressing “Lower”, “Lift” and “Stop” keys. Then mount the specimen properly with pneumatic clamp.

Open the catalog to page 1

i-STRENTEK 1100 Auto Tensile Tester---Floating Roller Method Test-2

200 River's Edge Drive, Medford, MA 02155

Open the catalog to page 2

i-STRENTEK 1100 Auto Tensile Tester---Floating Roller Method Test-3

200 River's Edge Drive, Medford, MA 02155 Historical Test | Real-time Data | File Management ] Test Date |2012 Y p |~iearch | |System Storage J3 Load | Tensile Test Tensile Strength and Elongation Rate Tensile stress at Break and Elongation Rate ■Tear strength 90 Degree Peel Strength ISO Degree Peel Strength ■Tensile Strength at Fined Elongation

Open the catalog to page 3

All Labthink Instruments Co., Ltd. catalogs and technical brochures

Archived catalogs

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list