*mydirectindustry

Catalogs
Labthink Instruments Co., Ltd.
i-STRENTEK 1100 Auto Tensile Tester---90 Degree Peel Strength Test

i-STRENTEK 1100 Auto Tensile Tester---90 Degree Peel Strength Test

Product catalog summary

Scope
The i-STRENTEK 1100 Auto Tensile Tester is a versatile device designed to measure various mechanical properties such as tensile, peeling, tearing, and adhesive forces. It is applicable to a wide range of materials including plastic films, composite materials, flexible packaging, adhesives, medical plasters, and more.

Test Procedures

Preparation: Test specimens should be prepared according to specific standards. Adhesive tape is applied to the test plate.
Adjustment: Adjust the space between the upper and lower sample grips using the “Lower”, “Lift”, and “Stop” keys to fit the specimen. Proper mounting with a pneumatic clamp is essential. During a 90-degree peel test, ensure the space between the fixture and lower grip is monitored closely, stopping immediately if it is less than 15mm to prevent damage.
Setup: Configure test parameters, specimen parameters, and select the appropriate test speed before initiating the test.
Data Recording: Observe and record the test data. If the test curve is unsatisfactory, discard the results and repeat the test with a new specimen until valid data is obtained.

Catalog excerpts

i-STRENTEK 1100 Auto Tensile Tester---90 Degree Peel Strength Test-1

i-STRENTEK 1100 Auto Tensile Tester---90 Degree Peel Strength Test Scope i-STRENTEK 1100 Auto Tensile Tester is designed to determine the tensile, peeling, tearing, heat sealing, adhesive, piercing, opening, low speed unwrapping and pulling force of the plastic film, composite material, flexible packaging material, plastic tube, adhesives, adhesive tapes, medical plasters, release paper, protective films, combination caps, aluminum foils, diaphragm, back sheets, non-woven fabrics, rubber and paper etc. Test Procedures A: Prepare test specimens according to specific standards. Then stick the adhesive tape on the test plate.

Open the catalog to page 1

i-STRENTEK 1100 Auto Tensile Tester---90 Degree Peel Strength Test-2

B: Adjust the space between upper sample grip and lower sample grip to meet the requirements of the specimen by pressing “Lower”, “Lift” and “Stop” keys. Then mount the specimen properly with pneumatic clamp. Keep observing the space between the fixture for 90 degree peel test and the lower sample grip after pressing the “Lower” key. Press “Stop” key immediately when the space is less than 15mm to stop the motion of upper sample grip. Otherwise the instrument may be damaged seriously. C: Set up test parameters, specimen parameters and select proper test speed. Then start the test.

Open the catalog to page 2

i-STRENTEK 1100 Auto Tensile Tester---90 Degree Peel Strength Test-3

200 River's Edge Drive, Medford, MA 02155 Historical Test | Real-time Data | File Management ] Test Date |2012 Y p |~iearch | |System Storage J3 Load | Tensile Test Tensile Strength and Elongation Rate Tensile stress at Break and Elongation Rate ■Tear strength 90 Degree Peel Strength ISO Degree Peel Strength ■Tensile Strength at Fined Elongation

Open the catalog to page 3

All Labthink Instruments Co., Ltd. catalogs and technical brochures

Archived catalogs

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list