Catalogs >
Labthink Instruments Co., Ltd. >
i-LEAKTEK 6600 Leak and Seal Strength Tester -Pilfer-proof Closure Test

i-LEAKTEK 6600 Leak and Seal Strength Tester -Pilfer-proof Closure Test
4Pages

Catalog excerpts

i-LEAKTEK 6600 Leak and Seal Strength Tester -Pilfer-proof Closure Test - 1

i-Leaktek 6600 Leak and Seal Strength Tester---Pilfer-proof Closure Test Scope i-Leaktek 6600 Leak and Seal Strength Tester is designed for determination of seal strength and seal performance test of various heat sealed flexible package and sterilized package, seal performance test of pilfer-proof closures, quantitative testing of leak characteristics, compression resistance, capsule disengaging strength, cap body joint strength, seal-edge seal strength and butting strength of flexible tubes, and testing of anti-compression, seal performance and burst resistance of the bottles. LSSD-01C Fixture for Plastic Pilfer-proof Closure Test could be used to test the seal performance of the plastic pilfer-proof closure. The mouth diameter of the plastic pilfer-proof closure to test should be 28mm or 38mm. For other specifications, customization is available. Test Procedures A: Power the instrument on and warm up for at least 30 minutes. Fill the container with clean water. Prepare the specimen as required. The number of specimens should be not less than 5 and should be free of visible imperfections. Prepare a bottle whose cap has been closed in the demanded lock forces. Cut down the specimen with cap from the bottleneck in 5 mm distance to the flange. Then mount the specimen.

Open the catalog to page 1

i-LEAKTEK 6600 Leak and Seal Strength Tester -Pilfer-proof Closure Test - 2

200 River's Edge Drive, Medford, MA 02155

Open the catalog to page 2

i-LEAKTEK 6600 Leak and Seal Strength Tester -Pilfer-proof Closure Test - 3

B: Put the fixed specimen on the supported board with the incision upside down, now, it is immerged in the water. Take gas pipes into the safe gap of the container, then put on the cover of the container and turn it counterclockwise to the end to lock it. But don’t put too much force when you turn the cover. C: Set up test parameters and select “Creep Test”. Then set pressure, time, amend value and amplitude. Click “Set” button to save the parameters and click “Start Test” to start the test. Observe whether there is leakage, air bubble, or break off of cap in the whole test process. When...

Open the catalog to page 3