FlexWall® FW120/0 -(H33) Volumetric and gravimetric General Information The FlexWall® FW120/0 is a feeder ideal for poor or difficult flowing bulk ingredients. The feeder has the following main components: a stainless steel rectangular housing, a flexible polyurethane trough with a large cross-section, massage paddles, a screw, a screw tube, a 3 phase motor and an extension hopper with volumes of 350 dm³ (12.36 cuft) or 600 dm³ (21.19 cuft). The shape of the trough and the external adjustable amplitude massage paddles work together to provide consistent screw filling and mass flow without ingredient deterioration. Screw removal of the FW120/0 is from the front. The FlexWall® is easily disassembled for wet or dry cleaning as the polyurethane trough that is attached to the housing is easily removed. The gravimetric version includes the H33 weighing system featuring a high resolution digital load cell with serial data transmission and advanced filtering technology. The unit conforms to CE directives. Model Specification Screw drive Drive power Screw speed Massage paddles Separate paddle drive Control Modules Control and speed modules are offered either mounted onto the feeder (Congrav® CM-E) or are available for mounting in a separate control panel (Congrav® CB-E or Congrav® CB-S ). Controls can communicate directly to most host/ PLC systems or to Brabender Technologie Congrav® Operator Interfaces. Technical Drawings and Dimensions volumetric feeders 350 dm³ (12.36 cuft) Hopper 600 dm³ (21.19 cuft) Hopper Kubota Brabender Technologie GmbH, Kulturstr. 49, 47055 Duisburg, Tel.: +49(0)203 9984-0, [email protected] gravimetric feeders Control module CB Changes reserved Status:

FlexWall® FW120/0 -(H33) Volumetric and gravimetric Available Screw Sizes and Feed Rates Screw type Spiral Screw (S) (TA= with trough activation) Tube designation Max. feed rate * [cuft/h] Spiral Screw (S) for granules * Theoretical values at 100% screw filling level and motor speed. Depending on the flow characteristics the screw filling level may decrease to 50%. Further limitations have to be considered for gravimetric feeding, as max. speed should be reduced to allow for bulk density variations. How to read the table of screws Technical Specification Ambient temperature: Humidity of the air:...