FlexWall®Plus FW40/6 Volumetric and Gravimetric General Information The FlexWall®Plus FW40/6 feeder is ideal for free flowing bulk ingredients. The feeder has the following main components: a stainless steel trapezoidal housing, flexible polyurethane trough with a large cross-section, a screw, a screw tube, a 3 phase motor and an extension hopper with volumes of 50 dm³(1.77 cuft) or 70 dm³ (2.47 cuft). The shape of the trough provides consistent screw filling and mass flow without ingredient deterioration. Screw removal of the FW40/6 is from the front of the feeder. The FlexWall®Plus is easily disassembled for wet or dry cleaning as the polyurethane hopper that is attached to the housing is easily removed. Moreover, the compact trapezoidal shape allows up to 6 feeders to be arranged around a central feed point. All service is be from the front or back. The gravimetric version includes the analog weighing system MS5, or the digital weighing system MD5 (for highest measurement accuracy), featuring a high resolution robust digital load cell with serial data transmission and advanced filtering technology. The unit conforms to CE directives. Model Specification Screw drive Drive power Screw speed Screw speed optional Massage paddles Control modules Control and speed modules are offered either mounted onto the feeder (Congrav® CM-E) or are available for mounting in a separate control panel (Congrav® CB-E or Congrav® CB-S ). Controls can communicate directly to most host/ PLC systems or to Brabender Technologie Congrav® Operator Interfaces. Technical Drawings and Dimensions volumetric feeders 50 dm³ (1.75 cuft) hopper 70 dm³ (2.45 cuft) hopper Kubota Brabender Technologie GmbH, Kulturstr. 49, 47055 Duisburg, Tel.: +49(0)203 9984-0, [email protected] gravimetric feeder Control module CB Changes reserved status:

FlexWall®Plus FW40/6 Volumetric and Gravimetric Available Screw Sizes and Feed Rates Screw type Tube designation Max. feed rate* [cuft/hr] Spiral screw (S) for granules * Theoretical values at 100% screw filling level and motor speed. Depending on the flow characteristics the screw filling level may decrease to 50%. Further limitations have to be considered for gravimetric feeding, as max. speed should be reduced to allow for bulk density variations. How to read the table of screws Technical Specification Ambient temperature: Humidity of the air: max. vacuum/pressure: Product temperature: 3 hPa...