Catalogs >
Kubota Brabender Technologie GmbH >
Work Standard - Congrav CM-E

Work Standard - Congrav CM-E
2Pages

Catalog excerpts

Congrav® CM-E 3.0 Feeder Controller General Information The Congrav® CM-E 3.0 is the latest generation of feeder mounted and pre-wired controller for all Brabender Technologie loss-in-weight or weigh belt gravimetric feeders. There are two modules for each feeder, the Congrav® CM-E feeder control module and the FC CM module for motor speed control. These modules work together to provide dependable and accurate feeding. The Congrav® CM-E 3.0 is supplied with power via the FC CM. Each Brabender Congrav® CM-E 3.0 module has multiple advanced RISC processors that perform the calculations necessary to provide accurate feeder performance and is designed for demanding industrial environments. The control module Congrav® CM-E 3.0 is interconnected by a bus and connected to either the Congrav® OP1-S (for a single feeder) Congrav® OP6-E (up to 6 feeders) or the Congrav® OP16-E (up to 16 feeders) Operator Interface via a single cable connection (SCC). The controllers can also communicate directly with most host/SPS systems, whether as a single component or multi-component controller. The unit conforms to CE directives and is characterized by high electromagnetic compatibility. Inputs and outputs Inputs 6 digital inputs* (24 VDC) often used for start/stop or interlock. 1 digital input can be used as frequency input for digital speed measurement. 6 digital outputs* (24 VDC) often used for run, refill and alarms. *1 input/output is occupied internally – only 5 inputs/outputs are available for customer use Interfaces The control module Congrav® CM-E offers several interfaces including: Interface Interface for IDL-F, MD, DLS load cell To read the load cell weight signal and DMS digital Module (RS 422) Host-/SPS-interface Communicate to host systems. Available protocols: Ethernet Modbus TCP, Profibus DP, Profinet, EtherNet/IP For communication to Congrav® OP6-E and OP16-E operator interface or PC for operation, diagnostics and maintenance To regulate motor speed For communication to Congrav® OP1-S single feeder operator interface for operation, diagnostics and maintenance Brabender Technologie GmbH & Co. KG, Kulturstr. 49, 47055 Duisburg, Tel.: +49(0)203 9984-0, email@brabender-technologie.com

Open the catalog to page 1

Congrav® CM-E 3.0 Feeder Controller Technical Specification Technical Specification Housing material Ambient temperature Transport/storage: Air humidity Protection Dimensions (HxWxD) Mounting Weight Aluminium, painted (RAL 7035) 0°C to +45°C (32°F to +113°F) -20°C to +85°C (-4°F to +185°F) Up to 85% without condensation IP 65 200 x 200 x 72 mm On the gravimetric feeder 2 kg (4.4 lb) Electromagnetic compatibility (EMC) Electromagnetic compatibility (EMC) Emitted interference DIN EN 61131-2 : 2008 Test method: DIN EN 55016-2-3 Interference resistance DIN EN 61131-2 : 2008 Requirement ESD HF...

Open the catalog to page 2

Work Standard - Congrav CM-E 2Pages

Catalog excerpts

All Kubota Brabender Technologie GmbH catalogs and technical brochures

Work Standard - Congrav CM-E
2Pages