NAO 4 - 3E
1 / 2Pages

NAO 4 - 3E Cladding machine (MIG/MAG method) Cladding machine NAO series are suitable for the cladding of deep base surfaces for example cladding of valve seats up to 500 mm deep. If the standard torch is used (MIG/MAG) it is also possible to clad external rotating surfaces. It is possible to oscillate the torch during the cladding process depending on the width required. The most common method of cladding is MIG/MAG (wire or tubular wire). With this technology it is possible to clad through a minimum diameter of 20 mm and the maximum depends on the machines capability. Machine is fitted with 5 axes, 4 are controlled by the program and 5th is adjusted manually. The cladding machine NAO is suitable for engineering industry, energy industry and also for other application with maximum load of 1.000 kg. This technology it is possible to use for new and used parts. Standard welding material (stainless steel, nickel, cobalt, etc.): -solid wire (ø 0,8 - 2,0 mm) -tubular wire (ø 1,2 - 2,8 mm

W Welding source and wire feeder: I In standard configuration the „NAO 4 4“ is supplied with 500A welding s source. W Wire feeder is located close to the t torch. A All welding parameters as well as a led all movement of axes are controlled f from the machine control system. Feed range of torch: In three axes. Two of them are fitted with digital servo motors. X-right, left (digital servo motors) 1.400 mm Y- forward-backward (manual adjuster) 100 mm Z- up-down (digital servo motors) 600 mm Z X Y Control sy system: With 5,7 QVGA touch screen mount5,7“ ed in an air conditioned box fitted with B&R...