SERIES 1800 SCREENING/WASHING PLANT Model 1822PH Spec Sheet 25'-5" SCREEN KPI-JCI 6’ x 16’, 3-deck horizontal wet vibrating screen – V-belt drive assembly with 40-HP, 1200 RPM motor – Huck-bolted assembly – 1/4” plate steel side plates – 160-mm double-roll spherical self-aligned bearings – Triple shaft vibrating mechanism complete with keyless hold-fast hub locking assembly – Oval motion stroke pattern – Adjustable stoke amplitude (3/8” - 5/8”) – Adjustable stoke angle (30o - 60o in 5o increments) – Adjustable speed via adjustable motor sheave (675 - 875 RPM) – Fully contained oil splash lubrication system – Bolt-on tailgates, 24” feedbox and 4” discharge lips – Steel coil springs – Side tension drawbar screen cloth retention system (screen cloth is optional) FINE MATERIAL WASHER KPI-JCI Model 5036-25T (36” twin) fine material washer – Tank is of 3/16” (sides and bottom) and 3/8” (rear end plate) welded plate steel construction and includes a curved bottom with integral rising current manifold (4” dia. inlet) – Large undisturbed pool area with adjustable weir boards and overflow flume with 10” dia outlet – Double pitch, solid flight spiral assembly with standard AR steel inner wear shoes and standard urethane outer wear shoes – Greaseable, externally mounted Dodge Imperial E tail end flange bearing; greaseable Dodge pillow block head end bearing – Lower end seal - chrome plated stainless steel wear sleeve, water tight bellows type rubber seal and secondary grease seal – High efficiency v-belt drive assembly (one drive assembly per spiral) includes 15-HP TEFC motor and Dodge TA-II double reduction shaft mount reducer – Tapered discharge chute set at 45o angle to grade See Model 5036-25T Spec Sheet for additional information

PHYSICAL / OPERATING CHARACTERISTICS – Heavy duty 12” I-beam construction – Tandem walking beam axle arrangement with dual Dana 22,000# axles and eight (8) 11:00 x 22.5 tires – Fifth wheel king pin, air brakes, travel lights, mudflaps and cribbing locations WATER SYSTEM – All fresh water plumbing to a single 6” inlet located near the tail end of the fine material washer – Fine material washer manifold includes a 4” butterfly valve, 4” swing check valve and pressure gauge – 1” chase water plumbing with gate valves – Screen manifold with flow control valves for each spray bar – Fourteen (14) spray...