The Kongskilde Inline Venturi system in conjunction with the Kongskilde Multiair blower unit is efficient for conveying of various materials such as continuous edge trim from paper and film manufacturing and processing industries. Expanded polystyrene (E.P.S.), guillotine off cuts, roll ends, finished plastic products i.e. blow-moulded bottles, injection moulded products and blow/injection mould waste (Top, tails and sprues). In addition the system can be utilised for explosive fume/vapour ventilation by removing the air return unit and replacing the air return with a large diameter duct. Unlike conventional Venturi systems, the new Kongskilde Inline Venturi system offers improved suction allowing materials to enter directly into the piping. The Air Return unit returns the induction air back to the blower, thus permitting only the induced air and the products being conveyed, to pass freely through the Venturi. The Kongskilde Inline Venturi system in operation has no moving parts, therefore, low maintenance. The Kongskilde Venturi system is especially suitable for materials with low density, “odd shapes” or continuous lengths. The Kongskilde Inline Venturi system simply connects to all Kongskilde blowers and piping with the use of Kongskilde clamps. The Venturi system is available for adaption to OK100, OK160, OK200, 0250 mm and 0300 mm piping. An OK160 Air Return is also used with the OK100 Venturi. KONGSKILDE Air solutions /your success

Dimensions Long Taper Venturi system Subject to be changed without notice. 123001517 EXP/GB/Inline Venturi/DATA/0218 Dimension depends on Venturi adjustment. Kongskilde recommends that a telescopic pipe is installed in the straight section before the Ventur