Phone: +39 049 7641230 - Fax: +39 049 9344179 [email protected] - www.kmcorporate.com Wire Processing Technology KM3011 In line stripper crimper Model KM3011 is an “IN LINE” stripper crimper so stripping and crimping operations are made without moving the wire so to guarantee a high stability of the process. The machine is equipped with basic processing programs, with the possibility to store some personalized setups for special process.The machine can also run in “out hindrance” mode that means to strip the wire out of the miniapplicator hindrance. All machine information and settings are managed by comfortable touch-screen display. The machine is equipped by a blade retraction device for a safer cable stripping. KM3011 has been realized with a really compact wire gripper in order to make more approachable the front working area. The safety guard has more practical working window. As standard feature, KM3011 is equipped with fine adjusting , quick-change clamping system, carrier strip chopper device and scrap vacuum system and lighting of the working area. On request, the machine can be equipped with crimp force monitoring, bad crimping cutter device and special double stripping blades. All data and measures are indicative and can be changed without notice. Certain types of extremely hard, tough wires may not be able to be processed even if written within the indicated ranges. In case of doubt, KM Corporate is willing to produce samples of your wire. Power supply Power consumption Noise level Standard stroke Lower dead center Wire cross-section up to 4 mmq stripper + crimper (AWG 12) - up to 6 mmq. (AWG 10) only crimping Cycles/h Weight, kg Weight with packing Dimensions without coil holders Dimensions with packing Minimum stripping length 1.8 (opt. from 1,0 to 9,2 mm with short stripping kit) Maximum stripping length Minimum wire length