KLINGER sealex Quick, easy to assemble – sealing on a roll ® You are prepared for every eventuality with KLINGER ®sealex – ”safe sealing on a roll”. Under service conditions of –196°C up to +260°C and pressure of up to 150 bar KLINGER ®sealex offers secure sealing on a roll. KLINGER – The global leader in static sealing

KLINGER sealex: The universal sealing solution What’s so unique about KLINGER ®sealex? KLINGER ®sealex is a PTFE product manufactured from a unique, physically networked fibrillated material. It is composed of specially prepared fluorocarbons with exellent resistance to aggressive chemicals as well as offering secure sealing under high pressures, even permitting the use of the material in applications up to 150 bar internal pressure ratings. Replacement of conventional gasket materials KLINGER ®sealex offers particular advantages in applications which prove difficult for conventional materials:...

KLINGER sealex: The universal sealing solution Should it be required, you can use two strips of tape bonded over one another. When re-assembling the flange, you can work with the usual assembly torque – then fit and forget. There is no need to re-tighten the bolts with KLINGER ®sealex. However, if it is possible to retighten the flange assembly after 24 hours, then you can reduce the applied bold load by half. Despite its versatility and ease of handling. KLINGER ®sealex should not be viewed as a temporary solution, but as a high grade permanent seal with unique characteristics. Important approval...

KLINGER sealex The following applications of KLINGER ®sealex will give you some idea of the innovative uses of this product. Further references are available on request. KLINGER ®sealex in turbine construction Operating conditions: 8 bar at 240°C. A sealing material was required for a number of flanges in the low-pressure area of the turbine house of a nuclear power station. KLINGER ®sealex succeeded in replacing the traditional seals and reduced the time needed to clean the flange faces giving savings of some 40-workforce hours every time the joints were replaced. These savings are in addition...