Asymmetric Orange Peel Grapples The reliable asymmetric orange peel grapple KM 652/2 with half closing tines provides for an easy transport, resting flat against the crane arm and not pro-truding the width of the carrier machine. It is mainly used for handling scrap, waste and construction materials, and is available with five (KM 652-5/2) or six tines (KM 652-6/2) – depending on the task. ▷ Asymmetric construction: the grapple rests flat against the crane arm in its transport position (see below drawing). ▷ Special slot on the main carrier allows the transport of a big orange peel grapple, that does not protrude the width of the carrier (2,5 m). ▷ Half closing tines by default, completely closing at the points, for handling waste, scrap, loose materials, etc. ▷ Non-return valve garantees a secure retention of loads even when pressure drops. ▷ ong service life due to robust design – oil distributor and hydraulic hoses L are protected in the center part, generously dimensioned bearings, wearresistant shells made of 400 HB steel, cylinder with piston rod protection, stops for both end postitions of tines. S ▷ trong operation due to high closing forces (13 kN at 26 MPa operating pressure). Asymmetric orange peel grapples KM 652-5/2 and KM 652-6/2 Type orange peel grapple, non-return valve Accessories Type recommended KINSHOFER rotator for KM 652/2 Requirements of truck crane Operating pressure at oil flow: max. 26 MPa (260 bar) at 25 - max. 75 l/min Mind the pressure! Technical drawings upper suspension KM 501 Aufhängung KM 501 We reserve the right to amend specifications without prior notice. Kinshofer GmbH, 83607 Holz