1_INNOFILL PET DVF COMPUTER-CONTROLLED PRESSURE FILLER WITH A LONG FILLING TUBE Innofill PET DVF is a computer-controlled pressure filler with a long filling tube which applies the volumetric filling principle. In a large container, this filler is used for bottling beer into PET bottles. Machine Characteristics The visual configuration and design of the Innofill PET DVF is based on the KHS standard solution for filling PET bottles. The filler and capper block is controlled using the latest servo technology. Plastic grip elements that hold PET bottles via their neck ring ensure the highest level of safety and system unit and can be called up at the push of a button. Innofill PET DVF can be optionally operated with a single or three filling chambers. The filling process is realized by an underlayed long tube filling system. As a result, this ensures quiet, low-turbulence filling with low oxygen capture. With this method, the filling tube is fed very deeply into the bottle. Filling starts at the base of the bottle. Only the surface of the beverage comes into contact with oxygen. It is no longer necessary to pre-rinse the PET bottle with CO2 when using the reliability. No table is used in this filler concept. Filling Process The long tube filler system consists of long lifting elements and long filling tubes. The filling valves are attached on the outside on the distribution ring. Actuation of these elements takes place via pneumatic cylinders which control the entire filling process. Using pneumatic cylinders makes the filler flexible and easily customizable for use with various products and bottle sizes. All beverage-related and bottle-specific parameters are stored in the control long tube filling system. After filling, the pressure is pre-released in a regulated way before finally, in the last step, the bottle pressure is released to match the atmospheric pressure. The exact filling volume is achieved using the Innofill PET DVF by means of an electromagnetic inductive flow meter. The filling volume can be changed during production by entering new data. Interaction between the electromagnetic inductive flow meter and the long tube filling system enables product savings to be made in the filling process.

2_INNOFILL PET DVF COMPUTER-CONTROLLED PRESSURE FILLER WITH A LONG FILLING TUBE Capping Options The Innofill PET DVF filler for filling beer in large PET bottles is available in combination with a standard capper or a servo capper for plastic screw caps. 28 mm single-thread caps are processed. Using the servo capper, higher requirements are met in terms of hygienic design as well as the requirement for a narrow tolerance range in terms of the measured values relating to the opening. Technical Data Bottle contents: 1.0 l to 3.0 l Bottling temperature: 0 to 20° C Height: 130 to 360 mm Diameter:...