Spur Gears with Built-In Clamps Other Bevel Worm Screw Bevel Miter CP Racks R . Internal Helical Spur Products Gearboxes Gear Pair Gears Gears Gears & Pinions ac s Gears Gears Gears Specifications * The gear grade listed is the value before clamping.The precision grade of products with a module of less than 0.8 is equivalent to the value shown in the table. [Caution on Product Characteristics] © For products with a tapped hole, a set screw is included. © The allowable torques shown in the table are calculated values according to the assumed usage conditions. Please see Page 31 for more details. © The backlash values shown in the table are the theoretical values for the backlash in the normal direction of a pair of identical gears in mesh. @ The reference slipping torques shown in the table are experimentally obtained by attaching the gears to shafts with g6 tolerance and 0.4a surface finish. © Do not tighten the clamping screw without inserting a shaft, or the bore will be permanently deformed and will not accept a shaft. Allowable torque (kgf-m) [Caution on Secondary Operations] © As these are finished products, avoid performing secondary operations on the bore, with the exception of adding a keyway. © Perform secondary operations carefully as to not to distort the clamping groove. ■ How does the K-Clamp work? The K-Clamp uses a crescent shaped piece, appropriate for the size of the shaft as the pressure wedge to secure the gear on the shaft. Other Bevel Worm Screw Bevel Miter CP Racks Racks Internal Helical Spur Products Gearboxes Gear Pair Gears Gears Gears & Pinions Gears Gears Gears i. The slipping torque is affected by the fitting and clamping surface conditions. Remove as much lubricant as possible, and use the same size shaft as the bore, within h7 tolerances. K-Clamp gears are suitable for relatively small gears in light loads with the bore size ranging between <p 6 and (p12mm. The gear will slip on the shaft when the actual load exceeds the slipping torque. The use of a key in addition to the K-Clamp is recommended for heavier loads or large bores sizes.

Spur Gears with Built-In Clamps Other Bevel Worm Screw Bevel Miter CP Racks R . Internal Helical Spur Products Gearboxes Gear Pair Gears Gears Gears & Pinions ac s Gears Gears Gears Specifications * The gear grade listed is the value before clamping. The precision grade of products with a module of less than 0.8 is equivalent to the value shown in the table. Allowable torque (kgf.m) [Caution on Product Characteristics] © For products with a tapped hole, a set screw is included. © The allowable torques shown in the table are calculated values according to the assumed usage conditions. Please see...