Magnet powder brake MPB50
1Pages

Starting current* Min. torque (residual torque) Rated current Max. permissible speed (with heat sink)** Max. permissible slip power (with heat sink)** Max. permissible operating temperature Rotor moment of inertia**** Weight (with heat sink)**** Corresponds to the rated torque. The maximum torque is usually higher than the specified value. At very low speeds < 10 rpm, torque fluctuations may occur. For brakes without heat sinks, this is limited by the residual torque and the maximum permissible slip power. Value determined at room temperature (22°C). Taking into account the maximum permissible operating temperature, the brakes may also be overloaded momentarily. The values for the rotor moment of inertia and weight may change depending on the hollow shaft design. The brake is preconfigured for connection via a FASTIN-FASTON 250 quick-disconnect connector 42282-2 and connection housing 180907 from TE Connectivity. The required quick-disconnect connectors are included in the scope of delivery. Dimensions Hollow shaft diameter D (mm) Product code without heat sink Product code with heat sink Standard diameter Installation note All magnetic particle brakes must be installed in a horizontal position. The drawings drawingsand anddata datainin this this document document areare provided provided as general as general information information for our forcustomers. our customers. For specific For specific use cases, usea cases, separate a separate quotationquotation must be requested. must be requested. Kern AntriebKern stechnik GmbH accepts Antriebstechnik GmbHno accepts responsibility no responsibility for any errors for found any errors in thefound respective in the datasheets. respectiveKern datasheets. Antriebstechnik Kern Antriebstechnik GmbH reserves GmbH the right reserves to makethe changes right to its make products changes without to its products prior notice. without Thisprior also applies notice.to This products also applies currently to available productson currently the market, available provided on the thatmarket, – unlessprovided otherwisethat specified – unless – theotherwise modification specified in question – thedoes modification not restrict inthe product’s usability. question does notAll restrict goodsthe andproduct’s trademarks usability. mentioned All goods in thisand datasheet trademarks are thementioned property of in Kern thisAntriebstechnik datasheet areGmbH. the property of Kern Antriebstechnik GmbH. Kern Antriebstechnik GmbH Gutenbergstrasse 11 88046 Friedrichshafen