100-240V ModBUS ModBUS 48-60 VDC X-Monitor ModBUS Power Meter for 6-channel Continuous Current with OLED display and Hall effect sensors • Oled graphic display • Small Hall Sensor • Integrated calibration menu • ModBUS RTU protocol The KET-MDC-416 allows the measurement of 6 continuous currents with values between -2500 A and +2500 A. It uses small Hall sensors connected with a 2 m long cable as signal transducers. The display, of which it is equipped, allows the calibration of the sensor through the integrated menu, displays the six readings in Amperes, the reading in Volt, Power and Energy on the 6 channels. It is equipped with an RS485 interface with ModBUS RTU protocol compatible with the ModBUS bridge/Master KET-RMB-211 and the X-Monitor gateways and any other third-party ModBUS RTU master. The KET-MDC-416 is self-powered by the same voltage used for the energy calculation. APPLICATIONS For Industry 4.0 For Accounting TECHNICAL FEATURES GENERAL SPECIFICATIONS CASE POWER SUPPLY RS485 INTERFACE CURRENT SENSOR Protection Range: Front: IP40; Screw Terminals: IP20 Operative Temperature: -30 ÷ +70 °C Dimensions: 106,.3 x 90 x 62 mm (W x H x D) Mounting: Wall mounting or on DIN rail Required DIN modules: 6 DIN modules Electric Board Type: Industrial or switchboard Material: BBlend PC/ABS self extinguishing UL94-VO Supply Voltage: 20 ÷ 60 VDC Consumption: < 1.5 W @ 20 ÷ 60 VDC Connectors types: Screw terminal Supported Protocols: ModBUS RTU Connectors types: Spring clamps Sensor Type: Hall effect probe Current Range: -2500 ÷ +2500 A Typical Sensitivity: 280 V/T Precision: 0.5% Tolerance: 1% Linearity: ± 0.2% Linearity Range: -7.5 +7.5 mT Nonlinearity: ±1% Temperature Drift: < ±200 ppm/°C Noise Spectral Density: <125 nT/sqrt(Hz) (f = 10 Hz ÷ 10 Hz) Detected: Current and Voltage Calculated: Power and Energy for each channel, as well as total values, with energy calculation accuracy of 0.5%. MEASURING RANGE Approvals: CE Security: EN61010-1 Metrology: EN61000-6