pressed-in threaded The Mubux-A is a threaded insert or stud with multiple helically knurled rings, a tapered anchorage profile and a pilot end for easy push in. For all moulded parts made of hard Product features • Fast and easy to install. A special pilot end prevents inser- tion problems. • Relatively small diameter and mini- • Particularly cost-effective ponent and receiving hole The part requiring fastening should be flush with the threaded insert, see (1) For this reason the borehole (2) should countersunk. The Mubux-A press in flush into the formed part (1). Hole diameter and wall thicknesses are dependent on the material used for the formed part. Please enquire or ascertain by testing. For guideline values, see the works standard sheets. Hole depth The screw must not under any circum- stances come to rest at the bottom of Available versions • Standard length • Shortened version • Contact head for electrical contacts or simultaneous fastening of severa • Stud with and without contact head nsert the Mubux-A with pilot start downwards into the receiving hole and press in with the hand lever or a small press. Never knock in Mubux-A Mubux-A achieves outstanding pull- out resistance if inserted into moulded components immediately after removal from the mould, when the component has not yet fully cooled down. Mubux-A has also proven successful in some thermo plastic materials if embed- ded using ultrasound technology. MUBUX-A-lnternal thread —- All table values apply only if the screw length in the threaded insert.