Technical Datasheet HM E Series Turbine Flow Meters with Ermeto Fittings

Turbine Flow Meters – HM E Series The HM E turbine flow meter series (E for Ermeto Fittings) is used to measure continuous and discontinuous flow rates. They are mainly used for lubrication and non-lubrication media. They are particularly suitable for low and medium viscosity liquids, such as water, emulsions, glycol mixtures and light oils. Even the measurement of cryogenic fluids is possible. • Consumption measurement Only high-grade steels that can withstand corrosive liquids are used in the production of turbine flow meters. Combined with the use of tungsten carbide bearings, the HM E guarantees...

HM E Series – Turbine Flow Meters Technical Data – Sizes K-Factor4) (pulses/l) ≥ 1 cst Technical Data – General Measuring Accuracy ±0.05 % (under the same conditions) Measuring Span Standard: 1:10 Extended: on request Viscosity Range Housing: Wheels: Bearing: Medium Temperature See dimensional drawing (page 4) as per DIN 1.4404 [AISI 316L], others on request as per DIN 1.4460 [AISI 329], others on request Tungsten carbide sleeve bearing Exact type designation on request. Extended measuring ranges on request. 4) Average values for single sensors at viscosity of 1 mm²/s; higher viscosities may...

Turbine Flow Meters – HM E Series Dimensional Drawing Ermeto screw connection 30 mm [1.18 in] HME Rundmaterial Datenblattzeichnung 30 mm M20x1.5 [1.18 in] Dokumentname M16x1.5 Original KEM Document: HM_E_D_EN_220101_E001 | Copyright KEM, Subject to change without notice

HM E Series – Turbine Flow Meters Calibration In-house calibration is performed on volumetric calibration rigs or in our DAkkS calibration laboratory, depending on the needs of the client. The KEM calibration lab uses a high-precision load cell system. With an accuracy of 0.05 % for the mass and 0.1 % for the volume of flowing liquids, we occupy a leading position worldwide. The German Accreditation Body (DAkkS) has accredited the laboratory engineers, processes and measuring equipment in accordance with the international standard DIN EN ISO/IEC 17025:2018. The KEM calibration certificate not...

Liebigstraße 5 85757 Karlsfeld Germany Wettzeller Straße 22 93444 Bad Kötzting Germany Liebigstraße 5 85757 Karlsfeld Germany Wettzeller Straße 22 93444 Bad Kötzting Germany More distributors & partners can be found at: www.kem-kueppers.com KEM Küppers Elektromechanik GmbH | Liebigstraße 5 | D-85757 Karlsfeld | Tel +49 8131 59391 - 0 | Fax +49 8131 92604 Original KEM Document: HM_E_D_EN_220101_E001 | Copyright KEM, Subject to change without n