Capacitive Transmitter Series 41 X / 41 X Ei - 2 Pages

Add to MyDirectIndustry favorites
Capacitive Transmitter Series 41 X / 41 X Ei

Catalog excerpts

Capacitive Pressure Transmitter    Series 41 Xfrom 1 mbar full range* / resolution 1 jbar    SERIES 41 X Ei The Series 41 X combines the ceramic measurement cell for low pressure ranges with the j P electronics of the digital Series 30 transmitter. The pressure values from the signals of the pressure and temperature sensors are determined by polynomial compensation (see reverse). The values can be displayed and stored on a PC via an RS485 interface and programming can also be carried out. The transmitters are calibrated to the base range. The PROG30 software permits programming of the analog output signal in each section of the range within the base range (e.g. range 100 mbar. Output 4.. .20 mA for 20.. .60 mbar). With KELLER RS converters K-100 Series, up to 128 transmitters can be hooked together into a bus system and read by means of a PC or laptop. READ30 software allows the current pressure of each transmitter to be read or the pressure activity of several transmitters to be recorded or stored whilst “on line”. This pressure transmitter is also available as intrinsically safe version (Series 41 X Ei). It is used in explosion exposed areas, where the categories 1 and 2 are required. *by splitting the 10 mbar range Electrical Connections KELLER AG fur Druckmesstechnik CH-8404 Winterthur ■ +41 52 235 25 25 H info@keller-druck.com KELLER Ges. fur Druckmesstechnik D-79798 Jestetten +49 7745 9214 0 E3 eurocenter@keller-druck.com Edition 05/2010 Subject to alterations Companies approved to ISO 9001 ■fnr www.keller-druck.com

 Open the catalog to page 1

Specifications PR-41 X (relative) PD-41 X (diff.) Overpressure Neg. Overpressure Standard FS Pressure Ranges 30    100    300    mbar All intermediate ranges for the analog output are realizable with no surcharge by spreading the standard ranges. ** Option: Adjustment directly to intermediate ranges (below 20 pieces against surcharge). For higher pressure ranges and for “wet/wet”-differential applications, KELLER offers Series 33 X resp. Series 39 X. ** Note that the error band will then increase proportionally Supply (UB) 41 X Supply (UB) 41 X Ei Analog Output (scaleable) Load (kD) Error...

 Open the catalog to page 2

All KELLER catalogs and technical brochures

  1. KELLER

    36 Pages

  2. Series 26 Y

    2 Pages

  3. Series 26 W

    1 Pages

  4. Handpump K/P

    1 Pages

  5. K-114 BT

    3 Pages

  6. K-114

    3 Pages

  7. 21 ge

    1 Pages

  8. LEO 3

    1 Pages

  9. FA-23

    1 Pages

  10. Series 8

    2 Pages