Datasheet SKYREEF Blue

Product catalog summary

Overview: This document provides technical specifications for a series of hybrid blow molding machines, identified by model numbers such as 50S BLUE, 60D BLUE, and 90D BLUE. The specifications cover mold dimensions, machine capabilities, and energy consumption.

Specifications:

Mold Dimensions: The maximum width ranges from 660 mm to 1140 mm, and the maximum length is consistently 500 mm for most models, with some extending to 700 mm. The minimum thickness is specified as 2x 150 mm to 2x 250 mm.
Mold Weight: The maximum mold weight varies from 2x 350 kg to 2x 850 kg depending on the model.
Carriage and Clamp Stroke: Carriage stroke ranges from 670 mm to 1150 mm, while clamp stroke maximum is between 260 mm and 400 mm.
Blow Pin Stroke: Maximum blow pin stroke is consistently 200 mm, with some models reaching 250 mm.
Calibration Force: Ranges from 20 KN to 40 KN.

Blow Molding Machine Capabilities:

Clamping Force: Varies from 240/300 kN to 500 kN.
Closing Speed: Consistently 750 mm/s for most models, with some at 600 mm/s.
Dry Cycle Time: Ranges from 3.0 s to 4.3 s.
Drive Power: Hydraulic drive power ranges from 18.5 kW to 30 kW.

Energy Consumption:

Air Pressure: Required net pressure is between 8 - 10 bar.
Cooling Performance: Cooling performance for blow mold and extruder feed zone is specified for HDPE/HMWPE materials.
Additional Notes: Air consumption may increase with additional processes such as article venting and flash cooling. A compressor with higher capacity is recommended.

Important Notes: All descriptions, pictures, data, and dimensions are not binding. Kautex Maschinenbau GmbH reserves the right to change designs and specifications without notice.

Catalog excerpts

Technical Details - SKYREEF BLUE (Hybrid machine) 50S BLUE Mold Width Length Thickness Mold weight Carriage stroke Clamp stroke Blow pin stroke Calibration force Blow Molding Machine Clamping force Closing speed Dry cycle time * Drive power hydraulic Daylight between platens Approximate Values for Energy Consumption Air consumption ** Air pressure (required net pressure) Cooling performance for hydraulic (water inlet temperature max. 30°C) Cooling perform. for blow mold and extruder feed zone HDPE/HMWPE * Sum of the movements, independent of the process ** Intake volume at atmospheric pressure. The air consumption will increase in case of article venting, flash cooling, internal scew cooling and postcooling. It is therefore recommended that a compressor with higher capacity is installed All descriptions, pictures, data and dimensions are not binding. Kautex Maschinenbau GmbH reserves the right to change designs and specifications without notice.

Open the catalog to page 1

All Kautex Maschinenbau GmbH catalogs and technical brochures

Archived catalogs

Virtual Machines
1 Page
BC Connect
1 Page