Product Information Ultrasonic Flaw Detector ECHOGRAPH 1093 Multi-Channel Ultrasonic Test Electronics for Compact Automated Ultrasonic Testing Systems The ultrasonic flaw detector ECHOGRAPH 1093 has completely separate testing channels, which are controlled with the help of a higher-ranked host pc. This pc works as a user interface and helps the operator to configure the ultrasonic system. In measuring mode the host collects data, stores data and produces statistical evaluations. Each test channel has its own complete ultrasonic electronics with a maximum pulse repetition frequency up to 3.000 Hz. So each channel can drive its individual inspection task with its own parameter set. In consequence, the system electronics ECHOGRAPH 1093 is very flexible and fast. The device is especially suited for use in small automated inspection systems for the realisation of different inspection tasks (e.g. tube testing for longitudinal and transverse flaws and testing for lamination). The A-Scan of the selected channel is shown (the signals of all test channels are available at the interface) PC- & A-Scan-module (three Height Units) with two displays for simultaneous instrument setting and displaying of the A-Scan Operation indicator for each channel Double Ultrasonic boards (one Height Unit each); each board contains two separate channels (here a 4-channel solution is shown) Flaw indicator in monitor 1 and monitor 2 for each channel via red and yellow LED Industrial keyboard (one or two Height Units) in a lockable drawer PC & A-Scan module from rear side with signal interfaces and power supplies for the different testing channels. Two channel ultrasonic board from rear side with interfaces and connectors for the PC module and the probes. KARL DEUTSCH Prüf- und Messgerätebau GmbH + Co KG Otto-Hausmann-Ring 101 D-42115 Wuppertal Tel. (+49 -202) 71 92 - 0 Fax (+49 -202) 71 49 32 e-mail: [email protected] page 1 from 4

Product Information Ultrasonic Flaw Detector KARL DEUTSGH Clear Indication of monitor status separately for each channel File Installation Repott About Identification of the test task is separately editable for each Channel 4 (11027): Transversal Flaw Operator interface for individual configuration of each channel (here channel resp. device 4, green marked, from altogether 8 channels) Delayed Time-Base Sweep Time Base Range Gain Adjustment Measurement Selection USER GUIDANCE Screen Adjustment AMPLITUDE EVALUATION PROBE PARAMETERS Probe Type Often used parameters are | User: Level 3 (Administrator)...

Product Information Ultrasonic Flaw Detector KARL DEUTSGH Channel 4 (10028): Face ol Shaft [Chevrons] Measurement Selection Screen Adjustment Probe Type Sound Veloci Material Thick JKFJ I INSTRUMENT PARA^DRJ, 7 " Main menu as well as submenus are shown in clear text. So all menus are very comprehensible without reading The picture shows a four-channel system, were channel ... selectable colours for the A-Scan ... freezable echo dynamics curve ... Transmittertrigger: channels are synchronised, sequence controlled by cycle program ... Receivetrigger: transmitter controlled or 1st echo (immersion...

Product Information Ultrasonic Flaw Detector ECHOGRAPH 1093 Technical Data DISPLAY Quantity Screen type Screen size Resolution Scale Scale division (for A-Scan display) 2 (PC-menu, A-Scan) TFT monitor 7“ diagonal 800 x 480 pixels Electronically generated, switchable coarse: 10-fold horizontal, 5-fold vertical fine: 50-fold horizontal, 25-fold vertical A-SCAN-DISPLAY AND DIGITIZATION* Image refresh rate 50 Hz A-Scan display normal display (envelope curve) filled echoes echo dynamics curve RF display For the entire testing range Rectification Without (RF), full wave, positive, negative Suppression...