Catalogs >
Kanthal >
SERIES 500SP NON-INDUCTIVE BULK CERAMIC SLAB RESISTORS

SERIES 500SP NON-INDUCTIVE BULK CERAMIC SLAB RESISTORS
4Pages

Catalog excerpts

SERIES 500SP NON-INDUCTIVE BULK CERAMIC SLAB RESISTORS

KANTHAL GLOBAR Series 500SP Non-Inductive Bulk Ceramic Slab Resistors provide high power and energy dissipation in a compact size. Proprietary bulk ceramic “SP” material is used in a simple, efficient design that permits energy to be uniformly absorbed throughout the resistor body, thereby avoiding failure in a peripheral film or wire. The advantages of KANTHAL GLOBAR Bulk Ceramic Slab Resistors include: • Typical Applications: • • • • • • • • Inherently non-inductive, high reliability due to bulk ceramic Series 500SP Non-Inductive Bulk Ceramic Slab Resistors construction 15 watts per inch...

Open the catalog to page 2

SERIES 500SP NON-INDUCTIVE BULK CERAMIC SLAB RESISTORS - 3

STANDARD PRODUCTS Figure 2. With Straight Radial Tabs (G1) Figure 1. Without Tabs Length (L ± 1/16") [L ± 1.6mm] 1" [25.4mm] 20 Gage Steel Riveted Tab, Tin-Plated Hole Spacing (L-3/8'') ± 1/16'' [(L - 9.5mm) ± 1.6mm] Both Ends Aluminum Figure 3. With Right Angle Radial Tabs – same direction – (g2) 3/8'' Figure 4. With Right Angle Radial Tabs – opposite direction – (g3) Length (L ± 1/16") [L ± 1.6mm] 20 Gage Steel Riveted Tab, Tin-Plated 20 Gage Steel Riveted Tab, Tin-Plated Figure 5. With Low Profile Axial Tabs (h1) Figure 6. With Standoff Axial Tabs (h2) Length (L ± 1/16") [L ± 1.6mm] 20...

Open the catalog to page 3

SERIES 500SP NON-INDUCTIVE BULK CERAMIC SLAB RESISTORS - 4

Characteristics Temperature Coefficient Short Time Overload: Max. % change after 5 cycles – 10 times rated power, 5 seconds on, 90 seconds off Load Life Max. % change after 1000 hrs. rated power 1-1/2 hours on; 1/ 2 hour off Thermal Shock Max. % change after 10 cycles -55˚C to +125˚C Moisture Resistance Max. % change when tested per MIL-STD-202, Method 103 Power Rating Curve Resistor Surface Temperature Rise versus Power 340 300 Temperature Rise, degrees C (1) Note: hen required, Type SP material can withstand W short periods of use at red-heat conditions, i.e. up to 550 to 600°C Typical...

Open the catalog to page 4