^ELECTROMAGNETIC CHUCKS Model KET-U ROTARY TYPE Suitable for grinding inclined faces of jigs/fixture and metallic •Easy installation and an angle can be set as desired in a range •The rotary shaft with scale facilitates angle setting. Chuck controller required additionally ijFull-function chuck masters are available with both rectification and demagnetization functions. !&lf the magnetic force needs not be adjusted, use ES-M £The chuck controller and clamp parts are not included. The KANETEC chucks work best when a KANETEC chuck controller is used £The scaled ring can be used to set an angle roughly. When it is necessary to set the angle accurately, please use a Sine Bar Chuck or other suitable type Model KEZ-H HARD ATTRACTIVE FACE An electromagnetic chuck with a hardened attractive face. The face plate is less susceptible to damage and the frequency of self grinding can be reduced. Also for self grinding, the grinding wheel needs not be replaced, thus shortening the setup time. Chuck controller required additionally ri;The chuck controller and clamp parts are not included The maximum performance can be obtained by using the chuck controller Model EH-V Model KETV ELECTROMAGNETIC CHUCK WITH VACUUM CHUCK Chuck controller required additionally Vacuum system required additionally An electromagnetic chuck with a vacuum chuck function of grid seal type added. The vacuum chuck function enables it to hold nonmagnetic workpieces. •The vacuum chuck can be configured to a desired usage area using seal rubber. •Since vacuum is maintained by use of seal rubber, a high degree of vacuum can be maintained even when workpieces See "Vacuum Chucks" on pages from 39 to 41 also. i^This model is manufactured to users' requirements, Please contact us for specificatio