KEC-AR /AS/SR/BH/ KETB / ES-VB Model KETB Pneumatic floating type Control unit required additionally (Air pressure and side slip force) Air is jetted through air holes provided on the chuck work face to float a workpiece for easy positioning, mounting and dismounting and movement. The chucks can be air cooled by adding a cooling device. This model is for grinding, but a model for cutting is also available upon request. •Workpieces having strong residual holding power can be separated and floated by the pressure of a small amount of air for easy removal. •The optimum floating condition can be adjusted according to the materials, sizes and shapes of workpieces by increasing/decreasing the air pressure supplied from the control unit. •As a small amount of air is constantly jetted through air holes during grinding, intrusion of grinding fluid and ground powder can be •The air circuit in the chuck has a construction specially developed by Kanetec to minimize clog. •The control unit is an easy-to-operate special unit incorporating an air regulator, rectifier and demagnetizer. Side rail Back rail Power Cord 2—5m %.For applications where the output current more than 5 A is required, the controller and the air control unit come as specially fabricated separate units r^The applicable air pipe diameter is 0 8 or 012. r^The output is adjusted with a variable resistor