Grinding Manual Timber Max (T.C.T. Saw Blade) Yield Pro (T.C.T. Saw Blade) A New Dimension of Performance Date:　April 13, 2007 Number of pages: 1 Flank grinding Grinding Wheel: Wheel feed speed: Stock removal: SDC200P125BMD16 1.7mm/sec. 0.5mm Face grinding Grinding Wheel: Wheel feed speed: Stock removal: SDC325N85PBC55-1.0 1.0mm/sec. 0.05-0.5mm Top grinding Grinding Wheel: Wheel feed speed: Stock removal: SDC 200/600 N 100 DT 15-7.2 1.2mm/sec. 0.1-0.5mm General Comments and Recommendations Wet grinding, oil or water, is self-evident Make sure not to change the tooth angles (angles are mentioned on our saw blade and box) Make sure to remove all wear, only a sharp edge delivers a good cut quality and long edge life Make sure to recess the gullet area and the back of the tooth Interpretation of grinding wheel specifications can be found at www.asahi.co.jp or contact Kanefusa Conversation Table Mesh - FEPA Mesh: 170 200 230 270 FEPA: D91 D76 D64 D54 325 D46 400 M40 600 M25 1000 M16 1500 M10 For further information, please contact Kanefusa or a dealer in your area. All contact addresses are listed on our website or email to our Headquarter at [email protected] Kanefusa Corporation Ohguchi-Cho, Niwa-Gun Aichi-Ken, 4800192, Japan Phone: +81(0)587-95-7221 Fax:+81(0)587-95-7221 Email: [email protected] ©Kanefusa Corporation www.kanefusa.net