Grinding Manual ECO Saw Blade (T.C.T. Saw Blade) A New Dimension of Performance Date:　April 13, 2007 Number of pages: 1 Top grinding Grinding Wheel: SDC 200/600 N 100 DT 15-7.2 Wheel feed speed 1.2 mm/sec. Stock removal 0.1-0.3 mm Face grinding Grinding Wheel: SDC 140 N 125 BA41 (drill type, 6 mm diameter) 1.0 mm/sec. 0.1-0.2 mm Wheel feed speed: Stock removal: Top View Tooth Wheel H Flat tooth Inverted V tooth Flat tooth Inverted V tooth A A Flat tooth For best performance we recommend to alternate the direction of rotation of the grinding wheel at for the flat teeth The difference H shown in the figure above should not exceed 0.05mm The difference in of the angle A should not exceed 2 degrees. General Comments and Recommendations Wet grinding, oil or water, is self-evident Make sure not to change the tooth angles (angles are mentioned on our saw blade and box) Make sure to remove all wear, only a sharp edge delivers a good cut quality and long edge life Make sure to recess the gullet area and the back of the tooth Interpretation of grinding wheel specifications can be found at www.asahi.co.jp or contact Kanefusa For further information, please contact Kanefusa or a dealer in your area. All contact addresses are listed on our website or email to our Headquarter at [email protected] Kanefusa Corporation Ohguchi-Cho, Niwa-Gun Aichi-Ken, 4800192, Japan Phone: +81(0)587-95-7221 Fax:+81(0)587-95-7221 Email: [email protected] ©Kanefusa Corporation ©Kanefusa Corporation www.kanefusa.net www.kanefusa.net