Data sheet IP101i module • TCP/IP module for electricity meters • Collection of meter values, e.g. counts, load profiles and voltage quality via Ethernet/ Internet • Configuration for static or dynamic IP address • Status LEDs for Ethernet and service identification • Relay output for load control (230 VAC, max 100 mA) • Pulse input • NAT penetration and white li

Application The IP101i module is installed in Kamstrup’s electricity meters and can be used in connection with counts, load profiles and events such as voltage cut-offs. This data are transmitted via TCP/IP communication to the reading system of the electricity utility. Kamstrup A/S recommends using closed networks, and the IP101 module is thus capable of operating behind a NAT/firewall. Connection diagram Terminal 65-66 (input) Pulse input Terminal 18-19 (output) Relay output for load control

Technical data Communication Protocol IPV4 Ethernet 10 Mbit Electrical data Supply Power consumption Load control Via the module connector < 450 mW 230 VAC, 100 mA (Solid state) Status / pulse input (isolated switch) Limit values Cable length, max Cable capacity, max Leak current switch max Frequency, max Pulse duration, min. Pulse duration, max Pulses in before display reading changes Mechanical data Dimension (wxhxd mm) Temperature, storage Temperature, operation Relative humidity Mounting Density 41x19x41 -40 °C - +70 °C -40 °C - +60 °C < 95 %, non-condensing In the module area of the electricity...