Catalogs >
Kamoer Fluid Tech (Shanghai) Co.,LTD. >
KPHM400 Peristaltic Pump Data Sheet

KPHM400 Peristaltic Pump Data Sheet
1 / 3Pages

Catalog excerpts

Mini Peristaltic Pump Suitable for the transmission of viscous and non-viscous liquids Simple structure and high reliability Special design, the pump tubing is not easy to shift or damage Long lifetime of pump tubing Stool analysis and processing system Vaginal secretion analyzer Chemiluminescence detection platform Hydroponic nutrient dosing Code Description Number of rollers Pump Tubing Mounting Bracket 24V DC brushed motor （current 0.3A） 12V DC brushed motor （current 0.7A） 24V DC brushless motor （current 0.3A） 12V DC brushless motor （current 0.7A） 3 rollers PharMed® BPT tubing, 4.8mm(ID) x 8mm(OD) Silicone tubing, 5mm(ID) x 8.2mm(OD) L type bracket Blank means straight bracket Pump Tubing Code Tubing Material Silicone tubing · Great resistant to general chemicals, acid, alkali and oxidizing agents · Compatible with virtually all commercial cleaners and sanitizers · Low adsorption, good temperature resistance, not easy to aging · Suitable for transporting various low-corrosive liquids Note: The above test data is measured when the pump head runs continuously and uninterrupted at a speed of about 280 rpm, and the room temperature is 20 ℃ pure water without pressure until the pump tube cracks. The actual service life is aﬀected by factors such as medium, working conditions, temperature and humidity, voltage, speed, etc. The test data is for reference.

Open the catalog to page 1

Flow Rate Code Note：The above ﬂow parameters are measured with pure water without pressure at 20℃, room temperature and standard atmospheric pressure. Actually, depending on the medium and outlet pressure, there will be a certain error in the ﬂow rate. The data is used as a reference. The current value is the thickest tube reference current. The head, viscosity, and the length of the water inlet and outlet are aﬀected. Dimensions (unit: mm) Straight Bracket Mounting holes Kamoer Fluid Tech (Shanghai) Co

Open the catalog to page 2

Motor Wiring Diagram NO. Wiring instructions: 1. The positive pole of the red line power supply, the negative pole of the black line power supply, the white line speed control line, the yellow line signal feedback line (to measure the speed), the green line reversing line (ﬂoating reverse, connect to the negative pole of the power supply for positive rotation). 2. Speed control port: PWM and 0-5V two speed control methods, speed control range 13%-100% PWM frequency 10KHZ-30KHZ; amplitude: 5V, duty cycle 0-10% motor does not rotate, 11%- 100% speed regulation interval; 0-5V voltage...

Open the catalog to page 3