Catalogs >
KALEJA GmbH >
MAXI-GMF-8-30

MAXI-GMF-8-30
4Pages

Catalog excerpts

Industrial motor controller for brushed DC motors 24 VDC Design for output currents up to 8 A Control with the following functions: - overload shut-down - short circuit detection - integrated freewheeling diode - galvanic isolation To snap onto the DIN rail EN 50022 Unit width: 22,5 mm C€ Article number Operating data: Technical data: load circuit Nominal voltage Supply voltage_ Control inputs_ 28.03.2020 KL - Errors and technical modification subject to change. All rights reserved. KALEJA GmbH Strubelweg 14 D-73553 Alfdorf Tel.: +49 7172 93711 0 info@kaleia.com

Open the catalog to page 1

The module MAXI-GMF-8-30 is a one-quadrant DC motor control for use in an industrial environment. It guarantees the switching on and off of motors. The module has an integrated freewheeling diode and the digital inputs and outputs circuit are electrically isolated. 28.03.2020 KL - Errors and technical modification subject to change. All rights reserved. © KALEJA GmbH

Open the catalog to page 2

Open the catalog to page 3

| Safety notes Maximum operational data The maximum operating data may not be exceeded. Installation The installation and start-up must be performed by specialist personnel exclusively. All affected components must be disconnected from the mains. Start-up For the first start-up, the motor should be operated without load. Risk of death Do not touch live parts after switching on! The assembly must be operated exclusively on safety extra-low voltage. With operation on extra-low voltage (e.g. via autotransformer), death or injury can occur. Fire protection The assembly must be installed in a...

Open the catalog to page 4

MAXI-GMF-8-30 4Pages

Catalog excerpts

All KALEJA GmbH catalogs and technical brochures

MAXI-GMF-8-30
4Pages