15.02.2018 KL - Errors and technical modification subject to change. All rights reserved. KALEJA GmbH Strubelweg 14 D-73553 Alfdorf, Germany Phone: +49 7172 93711 0 [email protected]

Housing, terminals, printed circuit board _UL94V-0 After applying supply voltage, the module is ready for operation when the start up time has elapsed. The module is a two quadrant motor control for use in industrial environments. It ensures the switching on and off, as well as the controlled driving of motors. Over a DIP switch and two internal trimmer the motor current limit value for the overcurrent shutdown is for each direction of rotation adjustable. The continuous load current form the module is 6A. A digital output reports if the module is in overcurrent shutdown mode. Current monitoring...

Datasheet M2-MWT-6-30 06.34.007 Typical application: Standard 15.02.2018 KL - Errors and technical modification subject to change. All rights reserved. © KALEJA GmbH

15.02.2018 KL - Errors and technical modification subject to change. All rights reserved.

The module is internally protected with an overload shutdown. In case of rising of the motor current over the rated continuous load current the module switches of with a thermal safety function. After the shutdown the module is locked for a cooldown phase which is managed by the module. | Function: dynamic brake | Function: overload / short circuit detection The motor always stops with dynamic brake while When the module detects overload or short circuit on normal operation. the motor output, the motor switches off without dynamic braking. The motor can be restarted by means of a reset...

Datasheet M2-MWT-6-30 06.34.007 Temperature derating At 100% duty cycle and aligned modules with 10mm spacing the following diagram is valid. Dimensional drawing 15.02.2018 KL - Errors and technical modification subject to change. All rights reserved. © KALEJA GmbH

Maximum operational data The maximum operating data must not be exceeded. Installation The installation and start-up must be performed by specialist personnel exclusively. All affected components must be disconnected from the mains. Start-up For the first start-up, the motor should be operated without load. Risk of death Do not touch live parts after switching on! The assembly must be operated exclusively on safety extra-low voltage. With operation on extra-low voltage (e.g. via autotransformer), death or injury can occur. Fire protection The assembly must be installed in a switch cabinet, which...