Catalogs >
KALEJA GmbH >
06.34.001

06.34.001
5Pages

Catalog excerpts

-=KALEJA=-Industrial motor actuation for brush-type direct current motors 24VDC Design for switching currents up to 5A. Control with the following functions: - Reversal of direction of rotation - Rotational speed control (external) - Adjustable start ramp (external) - over-current shut-down - short circuit protection - dynamic brake To the snap-on DIN rail: EN 50022 und EN 50035 overall width: 17,5 mm 14.10.2016 HS - Errors and technical modification subject to change. Reproduction as well as electronic duplication only with our written permission. All rights reseved. © KALEJA GmbH 2016

Open the catalog to page 1

Housing, terminal, printed circuit board _UL94V-0 The module M2-MR-5-30 is ready to use after the start up delay. After the module is powered up the startup delay time starts to run. The module M2-MR-5-30 is a two-quadrant motor control with open loop speed control for DC motors, for use in an industrial environment. It guarantees the switching on and off and the controlled drive of motors. Through two analog inputs it is possible to set the start ramp gradient and the speed of rotation. The motor can be stopped with and without dynamic braking. ^Typical application: Standard |...

Open the catalog to page 2

| State tabie direction „left“ (1) 14.10.2016 HS - Errors and technical modification subject to change. Reproduction as well as electronic duplication only with our written permission. All rights reseved. © KALEjA GmbH 20

Open the catalog to page 3

Function: dynamic brake 14.10.2016 HS - Errors and technical modification subject to change. Reproduction as well as electronic duplication only with our written permission. All rights reseved. © KALEJA GmbH 2016

Open the catalog to page 4

Maximum operational data The maximum operating data may not be exceeded. Installation The installation and start-up must be performed by specialist personnel exclusively. All affected components must be disconnected from the mains. Start-up For the first start-up, the motor should be operated without load. Risk of death Do not touch live parts after switching on! The assembly must be operated exclusively on safety extra-low voltage. With operation on extra-low voltage (e.g. via autotransformer), death or injury can occur. Fire protection The assembly must be installed in a switch cabinet,...

Open the catalog to page 5

06.34.001 5Pages

Catalog excerpts

All KALEJA GmbH catalogs and technical brochures

06.34.001
5Pages