CB 1/23 Eco Basic incl. wheel wash unit Gantry wash system
13Pages

CB 1/23 Eco Basic incl. wheel wash unit The complete solution for a gentle cleaning of all prevalent vehicles with a maximum height of 2.30 m. Technical data Washing height (mm) Fresh water supply (volume) (l/min) Fresh water supply (pressure) (bar) Number of current phases (Ph)

Details Description The CB 1 Eco is a rollover plant for cars and vans in which the vehicle is positioned without the use of positioning lights. The plant has been designed and developed according to Kärcher's extensive expertise and experience. Wash process: The traffic film is gently removed by rotating wash rollers, followed by a rinse with chemical drying aid in the second brush pass. The new designed roof dryer blower lays the best basis for a good drying result which stands above industry standard. A fully automated PLC system controls the wash cycle. Controlled by light barriers, the...

Accessories Additional controls Signal device Special control box which supplies potential free signals for connecting up to three pumps in-stalled already on-site. On-site pumps can be: - under chassis wash - fresh water pressure increase unit - reclaimed water unit Order no. 3.812-371.0 Can patch cable 20 m Communication line between feed distributor which is installed at the energy chain and other components like frost protection and door control that are mounted in the technical room. Order no. 6.649-618.0 Can patch cable 50 m Communication line between feed distributor which is...

Brushes Carlite / PE brushes, washing height 2.30 m Order no. 2.641-537.0 Control cable Control cable 3x 1.5 mm2 (price per meter) Order no. 6.641-059.0 Covering elements Front panelling Installed horizontally on the upper part of the front side. In the parking position it covers / hides the roof brush. We recommend the front cover if the unit is open for public. Order no. 2.640-891.0 Rear cover including covering side brush carriage Installed horizontally on the upper part of the rear side. It is recommended for an outside installation or in drive through washing hall whenever the customer...

Energy supply Energy chain, wall mounted The hoses and cables are protected in an energy chain. This can be mounted either on brackets, the washing bay wall, or supports (for setting up outside). The energy chain is a "tidy" space-conserving form of energy supply. Length: 9 m Order no. 2.640-965.0 Energy chain on supports for mounting to the floor The hoses and cables are protected in an energy chain. This can be mounted either on brackets, the washing bay wall, or supports (for setting up outside). The energy chain is a "tidy" space-conserving form of energy supply. Length: 9 m Order no....

Fill level control cleaning agents 10 l chemical storage drum, empty Detergents can be stored on the plant. The available space can be used for either 2 x 25 l canisters, or 1 x 25 l and 2 x 10 l canisters or 4 x 10 l canisters. The concept of the plant allows the use of the same detergent (out of the same canister) for the two programs foam and shampoo and for the two programs drying aid and hot wax. Currently the detergents are only available in 25 l canisters. Thus the 10 l canisters are needed in case different detergents are used for each program or when the plant is equipped with the...

Frost protection system regarding the frost protection: With a manual switch the operator gives the signal to blow out the basic machine. Order no. 2.850-722.0 Extension of automatic antifreeze, process water mode Prevents the plant and vehicles from suffering any damage caused by temperatures below 0°C. In case of frost, the machine will stop the operation of further washes and will start a sequential blow out. Hoses, the water distributor and spray tubes will be emptied. Additionally, outlet valves which are located at bottom level of the water distributor open up after all water has been...

Pumps High-pressure pump HD-E 60/6 K2 l High-pressure pump including control unit to be installed in the technical room for supplying the side high-pressure or the under-chassis wash unit (2.640-342). Power: 3~ / 400 V / 50 Hz / 16 kW. Order no. 2.640-973.0 Medium pressure pump 16 bar Standing, multi-level medium pressure centrifugal pump including central switch cabinet. The pump must be supplied by a tank in order to ensure safe operation. Voltage: 3~ / 400 V / 50 Hz Order no. 2.641-061.0 Connection tube 2" Kit for connecting the high-pressure module to an external buffer tank (e.g. water...

Safety devices Safety switches to short hall, entrance / front Necessary if the safety clearance of 500 mm at a height of 2,000 mm is exceeded at the machine's front. The safety switches are required if the required safety clearances according to DIN 24446 cannot be complied with on the side, in front of or behind the wash gantry. This prevents the risk of crushing. The safety switches are fastened to the wash gantry on construction frames. The system shuts down if actuated. After inspection and rectification of the problem, the system can be switched on again with the "start" button. Order...

Sand filter systems Add on pump WRP 10000 submersible pump for WRP 10000 with float switch and equipment to fix pump at wall of pump pit Order no. 2.642-037.0 Add on water supply pump 50/4.3 medium pressure pump to supply wash plant with reclaimed water Order no. 2.642-039.0 Add on fresh water emergency supply to fill reclaimed water tank with fresh water, when lack of water happens Order no. 2.642-113.0 Add on base electric cabinet base for electric cabinet WRP 10000, WRP 20000 or add on water supply pump Order no. 2.642-116.0 Add on additional reclaimed water tank additional reclaimed...

Sand filter systems aeration hose hose for connection of aeration pump and membrane aerator of add on kit aeration Order no. 6.390-892.0 Control cable pump pit - WRP Order no. 6.647-276.0 Spray protection Spray protection side, washing height 2,30 m The spray protection is mounted to the outer side of the gantry near the side brushes. Made of a weather-resistant plastic tarp and fixed with stainless steel profiles. Its sophisticated design has been matched to the plant design. Order no. 2.641-090.0 Splash guard roof brush Order no. 2.641-471.0 Torsteuerung Gate control Order no. 2.641-002.0...