Application The K2 condensate pump has been specially developed for removing condensate from condensing boilers, air conditioning systems and air dehumidifiers. The K2 satisfies the highest requirements. It is distinguished not only by its modern design but above all by its consistently quiet operation, its compact tank dimensions and its reliability. The pump is ready to connect and operates fully automatically. The pump incorporates a built-in alarm. The wear-free sensor system monitors the running time of the pump and gives early warning of potential faults. This message can be conveyed to an external transmitter using the potential-free contact to generate a signal. The two-part design of the motor and collecting chamber and the clip fasteners at the side make for easy cleaning without tools. The K2 is resistant to acid condensate with a pH-value of ≥ 2.7. The maximum inlet temperature of the pumped media is 104°F (40°C). In the case of larger volumes of condensate or additional waste water, we recommend using the Hebefix above floor sump with a U 3 KS spezial. Performance For condensat ≥ pH 2,7 Extremly quiet operation Ready to connect Wall or floor mounting Alarm with watchdog timing monitoring Potential free alarm contact Swing-type check valve 6 m pressure tube with connector DN 50 Easy to maintain 43472-01 We reserve the right to change specifications without notice

Condensate pumpe Type Max. height x width x length Cable quality Cable length Weight approx. Code No. Tube extension, 6 m with connector JP27993 Elektrical data Type Type of current Voltage Volt Motor rating P1 W RPMmin"1 F.L.C Ampere Motor protection Plug Technical data Motor in plastic housing, floor-mounted or wall-mounted instal- lation, continuous shaft for pump impeller in tank floor, low-lying hydraulics with special open impeller for reliable ventilation, coll- ecting tank 1.4 I with 0.9 I net capacity, with 2 x 28 mm 0 and 1 x 33 mm 0 intake openings, floor to centre inlet 95 mm, 8/11...