TEC-55 Multi-Point controller for compressed air systems The TEC-55 is a multi-point timer controlled condensate drain, designed to control up to four valves (draining points). A typical compressor installation has a compressor, after cooler, dryer, filter(s) and a receiver (air tank). All draining points can now be centrally controlled by the TEC-55. This multi-voltage, sequential controller can drain up to four outlets and each outlet can vary in pressure rating ranging from 0 to 400 bar. COMMERCIAL BENEFITS * * * * Does not air-lock during Operation. Compressed air systems up to any size. One valve control point. Suitable for all types of compressors. TECHNICAL ADVANTAGES * * * Minimum pressure drop due to sequential valve purging. Any type of valve can be applied (direct acting, diaphragm etc.). Various pressure ranges possible (multi-stage compressor applications etc.). WARNING Failure to carry out regular routine draining can have catastrophic results. Compressed air systems can become contaminated and production schedules can get seriously disrupted – just because a simple duty has been neglected.

TEC-55 Multi-Point controller for compressed air systems Specifications Controller Number of outlets Supply voltage Load capacity Valve open time cycle Interval time Total time cycle Ambient temperature Indicators Output connections Mains connections Housing Protection 4 off 100 – 240 VAC/DC 50/60 Hz 2A, 40 W per drain Fully adjustable from 0.5 – 10 sec per outlet Fully adjustable from 0.5 – 10 sec Fully adjustable from 4.5 – 90 min 0 – 65 ۫C 6 LED’s (only 1 LED activated any time) Cords with DIN 4365oA connector Cords with assembled mains plug ABS, fire resistant, (GREY) IP 65 when correctly...