Data sheet Linear Actuator JC35L11 JC35L11 has a maximum thrust of 12000N and a maximum pull of 6000N, providing a good solution for the patient lift. JC35L11 shows its superior performances in the aspect of high load capacity, excellent IP rating, low noise level as well as some safety features, among which are: Brake to increase friction so that strengthen the selflocking ability. Safety nut to avoid unintended rapid lowering due to the damage of the nut. Electronic limit switches and mechanical limit. Manual lowering to ensure nursing carers could lower the actuator when power supplier has...

Technical specifications Full Load Full Load Power Supply When the actuators are not running, Jiecang’s control boxes could short-circuit the motor terminals (electrodes). Such solutions give actuators higher self-locking load. These data above are typical ones.

Dimensions with standard top clevis L=260(S ≤50) L=S+210(S>50) 12 20

Dimensions with manual lowering 28= with slot 6, hole 12.5, with bushing

Installing Dimensions of 10000N(spindle pitch of 2mm) Stroke Length(S) Retraced Length With manual lowering Safety nut does not matter Installing Dimensions of 12000N(spindle pitch of 4mm) Stroke Length(S) Retraced Length With manual lowering

JC35L11 Speed VS Load 8 Speed (mm/s)

Cable length Plug and cable Brake G=Cast steel body B09=Slot width 8.1, slot depth 32, hole 12.5 G=Grey Mounting position H=horizontal V=vertical Stroke/Retracted lenght Input voltage Speed at full load Load capacity Optional feature Y Hall sensor option P Anti-pitch option X=Manual operation+Only push +Safety nut