Catalogs >
JET EDGE >
WATERJET PIPE CUTTER

WATERJET PIPE CUTTER
1Pages

Catalog excerpts

Pipe cutter A Cut Above Suitable for potentially hazardous environments: • Cuts virtually any material without heat or flames Track Options: • 3, 5 and 10 linear-foot tracks • Low profile, rigid and vacuum tracks available • Pipe track: 6–60 inches (152–1524 mm) Movement Speed: Varies due to several ranges of gear reducers Head Manipulator • Drive unit adapts for use with straightline track or pipe cutting bands • Reversible drive motor with interchangeable gear drive • Precise speed control for accurate cutting feed rates • Center line mounting of abrasive cutting head • Adjustable angle for beveling cuts Permalign II Abrasive Head Length 10.94 in (27.8 cm) Weight 4.00 lbs ( 1.8 kg) Operating air pressure (min) 60 psi (4 bar) Water pressure (max) 60,000 psi (4100 bar) Orifice range .005 - .021 in (.127 - .53 mm) Nozzle range .020 - .065 ID (.508 - 1.65 mm) Max flow rate 2.1 gpm (7.95 lpm) High Flow Abrasive Head (for cutting thicker material or multiple layers) Length 7.55 in (19.1 cm) Weight 4.00 lbs ( 1.8 kg) Operating air pressure (min) 60 psi (4 bar) Water pressure (max) 45,000 psi (3100 bar) Orifice range .020 - .036 in (.51 - .91 mm) Nozzle range .095 - .125 ID (2.41 - 3.18 mm) Max flow rate 5.1 gpm (19.04 lpm) Abrasive Delivery System • Durable steel design • Two-wheel pneumatic tires with rigged frame • Air-regulated metering valve • Delivery rate: up to 3 lb (1.36 kg)/minute Jet Edge’s Pipe Cutter is a hydraulically controlled portable abrasivejet cutting system designed especially for cutting pipelines, reinforced concrete and metal structures. The Pipe Cutter can operate horizontally or vertically. A specially designed track allows the Pipe Cutter to clamp to standard sized pipe (6”-60” diameter) for pipe cutting operations. The Pipe Cutter also can be attached to a variety of tracks for cutting flat or curved surfaces for linear cutting applications. The Jet Edge Pipe Cutter system includes a Pipe Cutter carriage, hydraulic drive assembly, abrasivejet, abrasive hopper, abrasivejet mounting hardware, control panel, remote UHP control assembly and hoses. For standard operation, it requires a mobile intensifier pump to supply UHP water, plus an air compressor, hydraulic power, track, and orifices and nozzles. Required Equipment • A mobile intensifier pump to supply UHP water • Air compressor to supply abrasive hopper • Hydraulic power to operate support equipment • Track (see above for track options) • Orifices and nozzles to shape UHP water stream The Pipe Cutter is powered by a Jet Edge waterjet intensifier pump.

Open the catalog to page 1

WATERJET PIPE CUTTER 1Pages

Catalog excerpts

All JET EDGE catalogs and technical brochures

WATERJET PIPE CUTTER
1Pages