*mydirectindustry

Catalogs
JET EDGE
IP36-200 WATERJET INTENSIFIER PUMP

IP36-200 WATERJET INTENSIFIER PUMP

Product catalog summary

Overview: The document provides technical specifications for the Jet Edge Model IP36-200 Intensifier Pump, detailing its physical dimensions, motor specifications, intensifier characteristics, water requirements, and environmental conditions.

Physical Size: The pump measures 92 inches in length, 57 inches in width, and 61 inches in height, with an approximate weight of 6,200 lbs (2,812 kg) when filled with fluid.

Electric Motor: It features a high-efficiency TEFC electric motor with an output of 200 hp (149 kW). The full load amps are specified for different voltages: 233 amps at 460 VAC (60 Hz), 466 amps at 230 VAC (60 Hz), and 280 amps at 380 VAC (50 Hz).

Intensifier: The pump includes a single piston, dual plunger, reciprocating intensifier with two intensifiers. It has a nominal output pressure of 36,000 psi (2,500 bar) and an intensification ratio of 12:1, with a flow rate of 6.1 gallons per minute (23.1 liters per minute) and a maximum rated orifice size of .040 inches (1.02 mm).

Low-Pressure Water: The water must be pretreated with less than 100 TDS, a pH of 6-8, and silica less than 15 PPM. Supply requirements are 20 psi (1.4 bar) at a maximum temperature of 75°F (24°C), with filtration at 1 micron.

Coolant Water: The maximum temperature is 70°F (21°C), with a minimum supply of 0-15.0 gpm (0-56.8 lpm) at 60 psi (4.1 bar). It can remove 125,000 BTUs per hour.

Hydraulics: The reservoir capacity is 95 gallons (360 liters) with full flow filtration at 10 microns.

Environmental Conditions: The ambient room temperature should be between 50°F and 100°F (10°C and 37°C), with non-condensing relative humidity up to 95% at 100°F (37°C). An optional CE mark is available.

Catalog excerpts

Model ip36-200 intensifier pump Physical Size Length Width Height Approximate weight with fuid Electric Motor Motor output Motor type electric motor Full load amps @ 460 VAC (60 Hz) Full load amps @ 230 VAC (60 Hz) Full load amps @ 380 VAC (50 Hz) Intensifer Type plunger, reciprocating Number of intensifiers Nominal output pressure Intensifcation ratio Flow rate Maximum rated orifice size 2 36,000 psi (2,500 bar) 12:1 6.1 gallons per minute (23.1 liters per minute) .040 in (1.02 mm) Low-Pressure Water Type Supply requirements Filtration Pretreated, <100 TDS, PH 6-8, Silica <15 PPM 20 psi (1.4 bar) / 75O F (24 O C) maximum 1 micron Coolant Water Maximum temperature Minimum supply Ability to remove Hydraulics Reservoir capacity Filtration 95 gallons (360 liters) Full flow 10 micron Environmental Ambient room temperature Relative humidity Single piston, dual Optional CE Mark Available

Open the catalog to page 1

IP36-200 WATERJET INTENSIFIER PUMP

IP36-200 WATERJET INTENSIFIER PUMP

Catalog excerpts

All JET EDGE catalogs and technical brochures