model ip36-100 iP36-50 intensifier pump intensifier pump The 100-horsepower Jet Edge iP36-100 Mobile Intensifer Pump is capable of producing adjustable output pressures from 5,000 to 36,000 psi (345 to 2,800 bar), and flow rates from 0 to 3.8 gallons (0 to 14.38 liters) per minute The iP36-100 utilizes a pressure-compensated hydraulic system to drive plunger style intensifiers. The use of hydraulic fluid power provides smooth flowing UHP water resulting in long system life. Reliable and precise control of the electronically shifted intensifiers ensures superior performance standards with reduced operating costs. The iP36-100 water jet pump is built on a skid-mounted frame with lifting eyes and forklift guides provided for increased mobility. Physical Size L ength: 96 in (224 cm) Width: 37 in (94 cm) Height: 60 in (152 cm) Approximate weight with fluid: 4,600 lbs (2,087 kg) Electric Motor Motor output: 100 hp (75 kw) Motor type: High efficiency TE FC electric motor Full load amps @ 460 VAC (60 Hz) 119 Full load amps @ 230 VAC (60 Hz) 238 Full load amps @ 380 VAC (50 Hz) 145 Intensifier Type: Single piston, dual plunger, reciprocating Number of intensifiers: 2 Nominal output pressure: 36,000 psi (2,500 bar) Intensification ratio: 12:1 Flow rate: 3.8 gpm (14.38 lpm) Coolant Water Maximum temperature: 70° F (21° C) Minimum supply: 4 gpm (15.1 L/min) Ability to remove: 81,000 BTU’s / HR Hydraulics Reservoir Capacity: 104 gal (394 L) Filtration: Full Flow 10 Micron Environmental Ambient Room Temperature 50° -100°F (10° -37°C) Relative Humidity Noncondensing, Maximum 95% @ 100°F Optional CE Mark Available Low-Pressure Water Type Pretreated, <100 TDS, PH 6-8, Silica <15 PPM Supply requirements: 20 psi Filtration: On board, 1 micron