eco-jet waterjet pump Energy efficient and economical, Jet Edge’s ECO-JET direct drive waterjet pump produces up to 1 GPM of 55,000 psi ultra-high pressure water for precision waterjet cutting and surface preparation applications. Like all Jet Edge products, the ECO-JET features Jet Edge’s signature rock-solid construction for lasting performance. Advantages · Energy-efficient and eco-friendly - Uses up to 40% less electricity than a 50hp pump, but produces same output! · Economically priced without sacrificing quality. · Easy to maintain. · Powers any manufacturer’s waterjet system!* * Waterjet table or tool must be capable of sending a pressure relief signal to the pump. Specifications Power: Output Pressure: Flow Rate: Maximum Orifice: Power Supply: LWH: Weight: 30HP (22kw) 55,000 psi (3800 bar) continuous 1 GPM (3.8 L/min) .015 in (.38 mm) 3-Phase, 460 VAC (60Hz), 35AMP 50 inch x 32 inch x 46 inch 1270 mm x 820 mm x 1170 mm 1500 lb (680 kg); approximate ATTENUATOR Standard Features · High-efficiency TEFC motor · 1800 nominal motor speed (rpm) · User serviceable attenuator to reduce pressure fluctuations · Liquid-filled pressure gauges · UHP safety shielded tubing · U/L, CU/L listed industrial control panel Construction · Rugged all-steel welded framework · NEMA 12/13 rated electrical enclosure Environmental · Ambient Room Temperature: 50°–95° F (10°–35° C) · Relative Humidity: Non condensing, maximum 95% at 95ºF (35ºC) PLUNGER PUMP & HIGH PRESSURE ASSEMBLY Electric Motor · Motor Output: 30 hp (22 kw) · Motor Type: High Efficiency TEFC electric motor · Full load current: 35A @460VAC (60 Hz) 50A @380VAC (50 Hz) Low-Pressure Water · Type: Pretreated, <100 TDS, PH 6-8, Silica <15PPM · Supply Requirements: Coolant Water: 4 GPM (19 lpm) Feed Water: 4.5 to 5 GPM (17-19 lpm) Minimum pressure 60 psi (4.2 bar) Maximum temperature 70ºF (21ºC) · On-board filtration to 0.45 micron