WATERJET SYSTEMS CUTTING SYSTEM • Cuts virtually any material without heat or flames • Pneumatic reversible drive motor • Non-ferrous motion components • Lighweight suction cup mount Movement Speed: Varies due to several ranges of gear reducers Optional Linear and Pipe Cutting Tracks: • Low profile, rigid and vacuum tracks available • Pipe track: 6-60 inches (152-1524 mm) Master Control Station • Three-position directional valve for pneumatic drive unit • Dual air regulators for directional speed control • Control abrasive flow from console • One palm button shuts off UHP water and abrasives Vacuum Generator • Steel construction • Pneumatic control vacuum • Locking quick disconnects • Lightweight compact design Head Manipulator • Drive unit adapts for use with track or pipe cutting bands • Pneumatic reversible drive motor with interchangeable gear drive • Precise speed control for accurate cutting feed rates • Center line mounting of abrasive cutting head • Adjustable angle for beveling cuts Permalign II Abrasive Head High Flow Abrasive Head (for cutting thicker material or multiple layers) Abrasive Delivery System • Lightweight durable high-impact poly design • Two-wheel pneumatic tires with rigged frame • Air-regulated metering valve • Delivery rate: up to 3 lb (1.36 kg)/minute Designed for use in remote and potentially hazardous environments. Jet Edge's Spyde Abrasivejet Radius and Circle Cutting Syste can be set up on the side of tanks, small vessels and large diameter piping. It is held in place by vacuum cups and features a self-aligning centering pin for fast and reliable setup. Motion components are made from non-ferrous materials, and cutting head manipulators are powered by pneumatic motors, making the Spyder A master control panel allows operators to control the cutting head manipulators, direction, speed of travel, abrasive delivery and vacuum components from one intensifier pump.