Industrial Flame Photometer Designed for industrial analysis Supplied with Na, K, Li, Ba and Ca filters Low temperature, single channel Flame failure safety system Operates with propane, butane, natural The PFP7 is a low temperature, single channel flame photometer that is designed for the routine determination of sodium, potassium, calcium, barium and lithium concentrations. The flame failure safety system makes these products ideal for use in industrial and educational environments. The use of fine and coarse sensitivity controls allows for accurate measurements each and every time. Technical Specification consecutive samples using 10ppm Na set <2% drift over 5 min when continuously Interference from Na/K and Li equal in concentration to test element Recorder output Services Electrical Moisture and oil free, 6 litre/min @ 14psi Propane, butane, natural gas or LPG Ordering Information Part Code PFP7 industrial flame photometer supplied with Na, K, Ba, Ca and Li filters, connecting hoses and clips, compressor plug and drain trap Note: This product will only operate with the correct type of compressor and gas regulator as specified. * Voltage variants available see page 94 Jenway Catalogue Nebuliser Part code: