SG100-SG500 pneumatic measuring systems for inner and outer diameters

Product catalog summary

Overview
The document provides technical specifications and features of the Gageline SG100, SG200, and SG500 measuring systems designed for high-precision, semi-automatic measurement of cylindrical workpieces. These systems are suitable for both inner and outer diameter measurements and are equipped with advanced pneumo-electronic transducers for high linearity and fast measurement cycles.

Key Features

IP65 protection for shopfloor use.
Simple test plan control and automated measurement runs.
High linearity and very fast measurement cycles.
High-precision, semi-automatic measurement capabilities.

System Components

Evaluation unit with Sirius and Tolaris Premium software.
Linear unit with associated electronics.
Pneumo-electronic transducer TPE200.
Pneumatic gaging components including air spindles and air ring gages.
Setting master for calibration.

System Features

SG100 for inner diameters, SG200 for outer diameters, and SG500 for combined measurements.
Scanning or incremental measurement on different levels.
Synchronous recording of measured values and position in Z-axis via CANopen motion controller.
Emergency stop button and crash protection system for the gaging tool.
Easy access to pneumatic and electronic connections for maintenance.
Optional dynamic measurement with rotating workpiece.

Technical Data

Total measuring stroke: 200 mm (linear unit).
Measuring stroke: 100 mm.
Inner or outer diameter range: 1 – 25 mm.
Measuring range: 5 – 40 µm.
Repeatability: 0.05 µm (6S).
Max. number of measuring levels: 127.
Measurement speed: e.g., 2 sec./cm (depends on system configuration).

Contact Information
JENOPTIK Industrial Metrology Germany GmbH, Alte Tuttlinger Strasse 20, 78056 Villingen-Schwenningen, Germany. Phone: +49 7720 602-0, Fax: +49 7720 602-444, Email: [email protected], Website: www.jenoptik.com

Catalog excerpts

SG100-SG500 pneumatic measuring systems for inner and outer diameters-1

High-precision, semi-automatic measurement runs Gageline SG100, SG200 and SG500 The SG100 – SG500 measuring systems allow for measurement of outer or inner diameters of different types of cylindrical workpieces. Characteristics measured –– –– –– –– –– Diameters on different levels Zero backlash Dynamic diameter measurement (profile evaluation) Matching tolerance of two workpieces Conicity Your advantages –– –– –– –– IP65 protection for use on the shopfloor Simple test plan control Automated measurement runs High linearity thanks to high-end pneumoelectronic transdu

Open the catalog to page 1

SG100-SG500 pneumatic measuring systems for inner and outer diameters-2

High-precision, semi-automatic measurement runs Gageline SG100, SG200 and SG500 SG100 for measurement of inner diameters SG200 for measurement of outer diameters System components Technical data Measuring stroke Inner or outer diameter Measuring range Measurement speed e.g. 2 sec./cm (depends on the selected system configuration) * larger workpiece dimensions on demand JENOPTIK Industrial Metrology Germany GmbH Alte Tuttlinger Strasse 20 | 78056 Villingen-Schwenningen Germany | Phone +49 7720 602-0 | Fax +49 7720 602-444 [email protected] | www.jenoptik.com –– Available measuring systems:...

Open the catalog to page 2

SG100-SG500 pneumatic measuring systems for inner and outer diameters

SG100-SG500 pneumatic measuring systems for inner and outer diameters

Catalog excerpts

All JENOPTIK Industrial Metrology Germany GmbH catalogs and technical brochures