TRE-QUATTRO GPS L1/L2, GLONASS L1/L2, Galileo E1 BeiDou B1, SBAS L1, QZSS L1/L2 TRE-QUATTRO OEM board is based on the TRIUMPH2 technology implemented in our 864 channel chip. The board accepts inputs from up to four antennas. It is equivalent of four receivers which operate synchronously with a common oscillator and central processor to coordinate all communications and other activities. The main receiver can perform long baseline RTK in conjunction with a base. The other three receivers along with the main one can provide very fast and reliable orientation (attitude) solutions. The on-board power supply on TRE-QUATTRO board accepts any voltage from +6 to +40 volts and delivers clean filtered voltage where needed. This eliminates the risk of power contamination (ripples) that can be created when clean power is generated elsewhere and delivered to the board via cables. TRE-QUATTRO board also includes drivers for four LEDs, ON/OFF and function button controllers. In addition, the board comes with large amount of flash for data storage. The CAN interface in TRE-QUATTRO board is provided complete with all associated hardware and firmware, not just the CAN bus. The same is true with all the serial RS232/RS422 ports in our board. Simply stated, additional functions are not needed to incorporate any of our TRE-QUATTRO OEM board in most applications. In addition to timing strobes and event markers, the TRE-QUATTRO OEM board includes the option of complete IRIG timing system.

*5. Connect to ground to activate. Internal pull-up 2 kOhm to +3.3V. *6. AM sine-wave signal; 2.1Vp-p (Mark), 0.7Vp-p (Space). *7. Active Low input which is equivalent to ON/OFF button of the MinPad. The pin must be connected to GND permanently if the board is required to turn on automatically any time external power is applied to pins A2 and B2. 1. Active Low input from the FN button of the MinPad. Must be left open if not used. *2. LED1_GRN and LED1_RED are used to control the STAT LED of the MinPad. LED2_GRN and LED2_RED are equivalent to the REC LED of the MinPad. The output is a +3.3V driver...

Tracking Features • Total 864 channels: all-in-view • Advanced Multipath Reduction • Fast acquisition channels • High accuracy velocity measurement • Almost unlimited altitude and velocity (for authorized users) Data Features • Up to 20 Hz update rate for real time position and 100 Hz raw data (code and carrier) • 10 cm code phase and 1 mm carrier phase precision • IEEE 1588 protocol support • Hardware Viterbi decoder • RTCM SC104 versions 2.x and 3.x Input/Output • NMEA 0183 versions 2.x and 3.0 Output • Code Differential Rover • Code Differential Base • Geoid and Magnetic Variation models •...

Specifications are subject to change without notice JAVAD GNSS www.javad.com Rev.1.3 December 4, 2017