DATA SHEET

The TRE-3S OEM board is based on our TRIUMPH Technology. For the first time in the GNSS history, we offer up to 200 Hz RTK. TRE-3S is the only all-in-view receiver in the market that can track and decode the QZSS L6 (both L61 and L62) signal messages. 874 GNSS channels of this board allow tracking all current and future satellite signals. We offer highly stable digital filters (band characteristics do not change with age, input voltages, or temperature), improved GLONASS inter-channel bias performance (due to our flat digital filter shape), excellent new multipath rejection technique. Embedded...

5. Internal pull-up 5 kOhm to +3.3V 6. Connect to ground to activate. Internal pull-up 10k Ohm to +3.3V 7. AM sine-wave signal; 2.1Vp-p (Mark), 0.7Vp-p (Space). 8. Active Low input which is equivalent to ON/OFF button of the MinPad. After abnormal turn off because of external power failure, the boards turn on automatically when external power is restored. Active Low input from the FN button of the MinPad. Must be left open if not used. Simultaneous use of two USBs in HOST mode is not supported. LED1_GRN and LED1_RED are used to control the STAT LED of the MinPad. LED2_GRN and LED2_RED are equivalent...

TRACKING FEATURES • In-Band Interference Rejection (IBIR) • Spoofing detection • Advanced Multipath Reduction • Fast acquisition channels • High accuracy velocity measurement PERFORMANCE SPECIFICATIONS • Static, Fast Static Accuracy: • Kinematic Accuracy: • DGPS Accuracy: • < 0.25 m post processing; < 0.5 m real-time • Real-time heading accuracy: • 0.004/L [rad] RMS, where L is the antenna separation in • Cold/Warm Start/ Reacquisition: • < 35 seconds / < 5 seconds / < 1 second DATA FEATURES • Up to 200 Hz update rate for real time position and raw data (code and carrier) • 10 cm code phase and...

• On-board power supply accepts any unregulated voltage between +4.5 to +40 Volts • Keep-Alive Power input accepts any unregulated voltage between +4.5 to +40 Volts • The central pin of the antenna connector outputs +5 VDC to power LNA. The sourced current is 0.12A max. • Power consumption: • GPS+GLO+GAL+BDS: 3.7-3.9 (IBIR off)/4.4-4.6 W (IBIR on) • All in view - S-Band & L-Band off: 3.8-4.0 (IBIR off)/4.2-4.4 W (IBIR on) • All In view -L-Band off: 4.3-4.5 (IBIR off)/4.9-5.1 W (IBIR on) • All in view: 4.5-4.7 (IBIR off)/5.1-5.6 W (IBIR on) • High shock and vibration resistance • Digital connector:...