Catalogs >
Jabsco >
36770 series

36770 series
2Pages

Catalog excerpts

MODELS 36760-0115 FLANGEMOUNT 36760-0220 FLANGEMOUNT 36770-0115 FLEXMOUNT 36770-0220 FLEXMOUNT • Extended Life Induction Motor • Tough Reinforced Thermoset Plastic Housing • Continuous-Duty Motor with Thermal Overload Protection • Flangemount Mounts to any Flat Surface • Flexmount Universal Bracket Permits Outlet to Face any Direction • Slip-on Inlet Ducting Connection • Efficient High Volume Air Flow • Low Current Draw ! Explosion hazard. Motor can spark. Explosion & death can occur. Do not use where flammable vapors are present. • Corrosion-Resistant Materials Throughout The Jabsco AC blowers are ideal for ventilating equipment areas. They may also be used for engine room ventilation on vessels with diesel powered engines only. THIS BLOWER IS NOT IGNITION PROTECTED. DO NOT USE TO EXHAUST FLAMMABLE VAPORS SUCH AS GASOLINE FUMES OR MOUNT IN AN AREA WHICH MAY CONTAIN FLAMMABLE FLEXMOUNT INSTALLATION Mount blower on flat bulkhead surface in highest part of compartment free from spray or deck wash. Blower may be rotated in mounting bracket to facilitate the shortest route of ducting. SPECIFICATIONS - Flexmount DIMENSIONAL DRAWING – Flexmount All wiring should be done by a qualified electrician and conform with regulations. A minimum of 16 gauge THW wire should be used for lengths of up to 50 feet from the power source. A separate ground wire should be secured to the grounding wire attached to the motor case and connected to a common ground. A switch of minimum 2 Amp rating may also be installed in the hot electrical lead (between breaker and blower) to control blower operation. The neutral conductor should be connected directly from the neutral buss to the blower motor. WIRE COLOR CODE Models 115 Volt Ground (earth) Green Common (neutral) White FLANGEMOUNT INSTALLATION Line (positive) Black The blower housing flange should be mounted on a flat bulkhead surface. Selection of a dry cool location will prolong motor life. When location is selected, cut a 3-5/8" hole through bulkhead to align with discharge port of blower. Secure discharge port flange to bulkhead using #10 screws and flat washers. Tighten screws evenly to avoid flange damage. SPECIFICATIONS - Flangemount DIMENSIONAL DRAWING – Flangemount CONTINUOUS DUTY 4" BLOWER • 115 VOLT AC, 60 Hz • 220 VOLT AC, 50 Hz

Open the catalog to page 1

Motor Kit 115 VAC Motor Kit 220 VAC (includes mounting nuts) Gasket Blower Housing Blower Wheel Blower Housing Screw 8 x 5/8 SS Self Tapping Pan Head Flexmount INSTALLATION DRAWING To Discharge Vent Part Number Flangemount INSTALLATION Inlet Ducting Tested At 115VAC Vent Cover THE PRODUCTS DESCRIBED HEREIN ARE SUBJECT TO THE JABSCO ONE YEAR LIMITED WARRANTY, WHICH IS AVAILABLE FOR YOUR INSPECTION UPON REQUEST. Maximum Static Pressure – 1.7 in. H20 (115 VAC) 1.2 in. H20 (220 VAC) Jabsco is a trademark of Xylem Inc. or one of its subsidiaries. © 2012 Xylem, Inc. 43000-0672 Rev B 10/2012 Inlet...

Open the catalog to page 2