Catalogs >
Jabsco >
35515-0010

35515-0010
2Pages

Catalog excerpts

Tough Reinforced Plastic Housing Universal Flexmount Bracket Permits Outlet to Face Slip-On Inlet and Outlet Ducting Connection Efficient High Volume Air Flow Corrosion-Resistant Materials Throughout N.M.M.A. Type Accepted Meets USCG Regulation 183.410 and ISO 8846 MARINE for Ignition Protection • Complies with ISO 9097 MARINE INSTALLATIONS MUST MEET APPLICABLE SECTIONS OF TITLE 33, PART 183; SUBPART K, USCG VENTILATION MOUNTING: Mount blower on flat bulkhead surface in highest part of compartment free from spray or deck wash. Blower may be rotated in mounting bracket to facilitate the shortest route of ducting. Use a suitable discharge fitting so that static pressure of blower will not be affected by change in wind direction. Route inlet ducting with as few bends as pos- sible to lower 1/3 of the bilge compartment where vapors are likely to accumulate. Be sure ducting is positioned below top of engine stringers but not so low as to become submerged in bilge water. Locate pickup to take advantage of natural air flow direction. Flexible ducting No. 34959-0100 is easy to cut and install. If installed as galley ventilator, blower should be mounted away from extreme heat. For exposed blower install, ventilator intake screen No. 34764-0000 provides a safe and attractive protected inlet. Jabsco blowers are primarily intended for intermittent duty cycles such as evacuating fuel vapors from bilge areas. If desired, they also may be used for other general air circulation applications with longer duty cycles. However, when doing so, it should be noted that the maximum motor life is approxi- mately 1000 hours. Therefore, the blower should only be used for applications if this length of service is acceptable. For con- tinuous duty applications, ask your dealer about Jabsco Heavy Duty Long Life Blowers. NOTICE: Blower should be mounted away from extreme heat (more than 130°F) to prevent distortion of blower wheel or housing. OPERATION: See following warning placard statement. Explosion hazard. Gasoline vapors can explode. Before starting engine, operate blower for 4 minutes and check engine compartment bilge for gasoline vapors. Run blower below cruising speed. Failure to do so can result in injury or death. WIRING: Use stranded copper wire. For lengths up to 25 feet (7,6 m) from power source: Use 12 gauge wire for 12 Volt. Use larger wire for longer lengths. Use a 10 amp rated on-off switch in positive side of circuit (Model 44960-0002 or 44960-0003). Circuit must be protected with a fuse. INSTALLATION DRAWING Inlet Ducting The "WARNING" placard supplied with blower must be mounted adjacent to engine ignition switches (all loca- tions) to comply with Title 33, Part 183; Subpart K, USCG Ventilation Regulations.* 'Additional warning placards are available from factory by

Open the catalog to page 1

PARTS LIST Key Part Description Part Number PARTS VIEW Bracket Assembly Blower Housing Blower Wheel Blower Housing Self Tapping Pan Head *Motor nuts not included. Order (2) 34681-0000 units. MARINE SWITCH PANELS Flojet is a trademark of Xylern Inc. or one of its subsidiaries.

Open the catalog to page 2