Current transducers_IDCS-U series
4Pages

{{requestButtons}}

Catalog excerpts

Current transducers_IDCS-U series - 1

Split-Core Current Transducer IDCS-U DC/AC current sensor, IDCSXXU series, applying with accurate laminating split-core technology and Open-Loop technology, has a strong durability and a good stability of error in low current and external vibration or shock. Features • One touch split core structure • Isolation measurement CATIII • Three Installation type: Panel mounting / DIN rail mounting / Cable tie mounting • Insulating plastic case recognized under UL94-V0 • Complied with CE and RoHSIII Advantages • Low power consumption with high accuracy • Easy mounting by Split-core structure • No insertion losses • DC Immunity Applications • Uninterruptible Power Supplies (UPS) • Monitoring and measuring Power supplies for Telecom • Switched Mode Power Supplies (SMPS) • Battery supplied applications • Chopper / Inverter monitoring • DC Power Meter

Open the catalog to page 1
Current transducers_IDCS-U series - 2

Split-Core Current Transducer IDCS-U Graphs Output Voltage Characteristic Frequency Characteristic Specifications are subject to change without

Open the catalog to page 2
Current transducers_IDCS-U series - 3

Wiring Diagram : Power supply 0V -15V (COM) +15V + 15V -15 V OUT 0V COM IN PUT Output measuring instrument This product needs ±15V (+15V and -15V DC bi-polar power supply) as operating power supply. Even if the case of detecting current with only plus direction, it still ±15V needs. In any case, it is not possible to operate with only +15V Safety The J&D CTs are UL/EN 61010-1, CE, RoHS compliant and certified, are also conformed up to Pollution degree 2, 600Vac CAT III rated devices. Please be sure that Failure to follow these instructions can result in serious injury and/or cause damage....

Open the catalog to page 3
Current transducers_IDCS-U series - 4

Split-Core Current Transducer IDCS-U Remark • • • • • Vo is positive when IP flows in the direction of the arrow. (o : output, p : primary current) Temperature of the primary conductor should not exceed 100°C(212°F). Dynamic performances (di/dt and delay time) are the best with a single bar when the primary hole is completely filled. By hysteresis of core, offset drift occurs proportionally to the over-current higher than rating value. The output value fluctuates upon the various factors, so it is recommended to use the current range higher than 5% of the rated current. • Do not use the...

Open the catalog to page 4

All J&D Smart Sensing catalogs and technical brochures

  1. Meter Catalog

    76 Pages